Abstract:The proposed WPT system: (A) The circuit configuration; (B) The inverter waveforms. Green and red lines are overlapped with black and red lines, respectively, for vS and i2 . All lines are overlapped for vg and it; and (C) The receiver waveforms. Blue and red lines are overlapped with black and green lines, respectively, except VOn . All lines are overlapped for VOn . This paper proposes a high‐frequency multiple‐receiver wireless power transfer (WPT) system with a load‐independent class‐E/F inverter. Each receiver has a post‐regulator, which changes the equivalent resistance seen from the inverter to obtain the necessary power for output voltage regulation. Because the load‐independent class‐E/F inverter generates constant AC current ( CCAC ), the transmitter supplies the minimum required power to the receivers by the change of the equivalent resistances. Besides, the load‐independent inverter consistently achieves zero‐voltage switching (ZVS) without any control. As a result, no information feedback by wireless communication is necessary for output regulation and ZVS achievement, simplifying the system configuration and improving the transient response of the control. This paper presents analytical expressions of the proposed system. Besides, the experiment was carried out with a two‐receiver WPT system. The implemented system worked well by individual and independent output regulation of the post regulator at each receiver. The implemented WPT system achieved the power‐delivery efficiency of 83.4% at the 6.78 MHz transmission frequency and the total output power of 40 W.

Single-Switch-Regulated Resonant WPT Receiver

Single-Stage Regulated Resonant WPT Receiver With Low Input Harmonic Distortion

Highly-Efficient Single-Switch-Regulated Resonant Wireless Power Receiver with Hybrid Modulation

A Novel Receiver for Dual-side Controlled Wireless Power Transfer System

2-20-V Wide Input Range Active Rectifier with Single-Multiplexing Adaptive Delay Compensation and Low-Voltage Enhancement for Wireless Power Transmission

Dual-Band Multi-Receiver Wireless Power Transfer: Architecture, Topology, and Control

Class E Active Rectifier with Controlled Output Voltage for MHz Wireless Power Transfer

Analysis and Design of a Cost-Effective Single-Input and Regulatable Multioutput WPT System

Single-stage Dual-Output AC-DC Converter for Wireless Power Transmission.

Reconfigurable Resonant Topology Linking Two-, Three-, and Four-Coil Modes for WPT with Large Coupling Range and Fixed Frequency

A 15 W Wireless Power Receiver with an Improved Full-Wave Synchronous Rectifier

Dual-Band Multi-Receiver Wireless Power Transfer with Reactance Steering Network

Design Methodology of the Power Receiver with High Efficiency and Constant Output Voltage for Megahertz Wireless Power Transfer

Novel Power Receiver for Dynamic Wireless Power Transfer System.

Analysis and design of high‐frequency multiple‐output wireless power transfer system with load‐independent class‐E/F inverter

A Resonant Inductor Integrated-Transformer Based Receiver for Wireless Power Transfer Systems

Maximum Energy Efficiency Operation of Series-Series Resonant Wireless Power Transfer Systems Using On-Off Keying Modulation

A 13.56 MHz Active Rectifier with Self-Switching Comparator for Wireless Power Transfer Systems

Pulsed Self-Oscillating Nonlinear Systems For Robust Wireless Power Transfer

Analysis and Design of Single-Ended Resonant Converter for Wireless Power Transfer Systems

Structure-Reconfigurable Power Amplifier (SR-PA) and 0X/1X Regulating Rectifier for Adaptive Power Control in Wireless Power Transfer System