Abstract:Internal friction in two kinds of iron-manganese alloy which contain Mn 17.5% and Mn 12.8% respectively and one kind of copper-aluminum alloy containing 13% Al were measured with a torsion pendulum, and internal friction peaks were observed in the temperature range in which the martensite or reverse martensite transformation is taken place. The condition for the appearance of this internal friction peak is that it occurs only when accompanied by the process of martensite-type transformation.Systematic observations were made with iron-manganese alloy containing 17.5% Mn, and it was found that the height of internal friction peak increases with the increase of the rate of heating (or cooling) or the stress, decreases with the increase of the frequency of vibration or the carbon content in the specimen. All these may be explained by the reason that the more the amount of new phase has transformed in one period of vibration, the larger is the internal friction.The mechanism of the internal friction peak was discussed. The conclusion was reached that because of the suddeness of the formation of martensite, the applied external forces due to torsion pendulum may be considered as constant during the time of formation for martensite plates, and since half of the work done by the external forces during the alteration must be lost as confirmed by the calculation of interaction energies between stresses and iuhomogenities, it consequently gives rise to the substantial portion of internal friction. On the other hand, the stress-induced phase transformation also gives rise to a minor portion of internal friction.

Study of Stabilization of CuAlBe Alloy During Martensitic Transformation by Internal Friction

Stabilization of deformed stress-induced martensite and its effect on shape memory effect in an Fe-Mn-Si-Ni-Co alloy

Modulus Softening During the Γ→ɛ Martensitic Transformation in Fe–25Mn–6Si–5Cr–0.14N Alloys

Investigation on the Internal friction of reverse martensitic transformation in Fe-Mn-Si based alloys

Internal Friction Analysis of Transformations in AuCuAl Alloy

A STUDY OF INTERNAL FRICTION ASSOCIATED WITH THE MARTENSITE TRANSFORMATION AT LOW FREQUENCY

Re-examination of martensitic stabilization in Cu-based shape memory alloys Part II. Key factors determining occurrence of martensitic stabilization in Cu-based alloys

Low Frequency Damping Properties of Cu–Al–Be Alloy During the Phase Transformation

The Investigation Of Internal Friction On Antiferromagnetic Transition And Martensitic Transformation In Mn-Fe(Cu) Alloys

In Situ Observation of Thermoelastic Martensitic Transformation of Cu-Al-Mn Cryogenic Shape Memory Alloy with Compressive Stress

Microstructure and martensitic transformation behavior of CuAlNb high temperature shape memory alloy

THE BEHAVIOR OF INTERNAL FRICTION ASSOCIATED WITH THE PROCESS OF MARTENSITE-TYPE TRANSFORMATION

Internal Friction and Modulus Changes Associated with Martensitic and Reverse Transformations in a Single Crystal Ni48.5Mn31.4Ga20.1 Alloy

Re-examination of martensitic stabilization in Cu-based shape memory alloys Part I. Identification of occurrence stage and degree of martensitic stabilization in CuZnAl alloys

The internal friction of the pearlitic, bainitic and martensitic transformations in FeNiC alloys

INTERNAL FRICTION ASSOCIATED WITH MARTENSITIC AND PREMARTENSITIC PHASE TRANSFORMATION IN THE Khz AND THE MHz RANGE

fcc Antiferromagnetism and martensitic transformation m Fe-Mn-Si based alloys

A Study of Friction-Induced Martensitic Transformation for Austenitic Manganese Steel

Martensite aging effects on the dynamic properties of Au–Cd shape memory alloys: Characteristics and modeling

Martensitic Transformation and Work Hardening of Metastable Austenite Induced by Abrasion in Austenitic Fe-C-Cr-Mn-B Alloy - A Tem Study

Impact of the Volume Change on the Ageing Effects in Cu–Al–Ni Martensite: Experiment and Theory