Abstract:An overview is presented on the structural and phase transformations and physical and mechanical properties of those multicomponent copper-based shape memory alloys which demonstrate attractive commercial potential due to their low cost, good shape memory characteristics, ease of fabrication, and excellent heat and electrical conductivity. However, their applications are very limited due to brittleness, reduced thermal stability, and mechanical strength—properties which are closely related to the microstructural features of these alloys. The efforts of the authors of this article were aimed at obtaining a favorable microstructure of alloys using new alternative methods of thermal and thermomechanical treatments. For the first time, the cyclic martensitic transformations during repeated quenching, methods of uniaxial megaplastic compression, or torsion under high pressure were successfully applied for radical size refinement of the grain structure of polycrystalline Cu-Al-Ni-based alloys with shape memory. The design of the ultra- and fine-grained structure by different methods determined (i) an unusual combination of strength and plasticity of these initially brittle alloys, both under controlled heat or hot compression or stretching, and during subsequent tensile tests at room temperature, and, as a consequence, (ii) highly reversible shape memory effects.

A Study of Structure of Metastable Cu–Zn Alloys with Shape Memory Effect

Stabilization of deformed stress-induced martensite and its effect on shape memory effect in an Fe-Mn-Si-Ni-Co alloy

Atomic-scale study on the precipitation behavior of an Al-Zn-Mg-Cu alloy during isochronal aging

Recent Electron Microscopy Results on Micro- and Nanostructured Ni-Ti-(X) Shape Memory Alloys

Structural and Phase Transformations and Physical and Mechanical Properties of Cu-Al-Ni Shape Memory Alloys Subjected to Severe Plastic Deformation and Annealing

Quantitative analysis of microstructure evolution in shape memory alloys during martensitic transformation

Study of the stabilization of ordered austenite β1 in Cu79Al19X2 (X = Be or Mn) alloys

Study on Aging Effect and Mechanism of Cu-11.1Al-6.5Mn-1.6Zn-0.1Zr Shape Memory Alloy

EXPERIMENTAL INVESTIGATION ON THE STRESS-INDUCED MARTENSITIC TRANSFORMATION AND THE MICROSTRUCTURE EVOLUTION IN CuAlNi SINGLE CRYSTAL

Structural-Morphological Fluctuations Induced by Thermomechanical Treatment in a Fe – Mn – Si Shape Memory Alloy

Microstructure of martensitic phase in the Co39Ni33Al28 shape memory alloys revealed by transmission electron microscopy

Re-examination of martensitic stabilization in Cu-based shape memory alloys Part II. Key factors determining occurrence of martensitic stabilization in Cu-based alloys

In Situ Observation of Thermoelastic Martensitic Transformation of Cu-Al-Mn Cryogenic Shape Memory Alloy with Compressive Stress

Strain intermittency in shape-memory alloys

Atomistic mechanism of η'-to-η transformation in Al-Zn-Mg-Cu alloys

Design and Development of High-Strength and Ductile Ternary and Multicomponent Eutectoid Cu-Based Shape Memory Alloys: Problems and Perspectives

Failure mechanism of reverse shape memory effect in a Cu-base alloy

Electron irradiation-induced evolution of the martensitic transformation characteristics in a CuZnAl shape memory alloy

Study of Stabilization of CuAlBe Alloy During Martensitic Transformation by Internal Friction

Structure and Martensitic Transformation in Rapidly Solidified CoNiAlFe Alloy

Re-examination of martensitic stabilization in Cu-based shape memory alloys Part I. Identification of occurrence stage and degree of martensitic stabilization in CuZnAl alloys