Abstract:Age hardening at 160 degrees C was performed in an Al-6.0 wt.%Zn-2.3 wt.%Mg-I.8 wt.%Cu-0.1 wt.%Zr alloy. It was found that metastable phases played a very important role in controlling this behaviour. The alloy reached the 193 HV peak hardness aged for 6 h. Transmission electron microscopy was used to characterise the morphology of iy phases as main strengthening precipitates, and then the high-resolution transmission electron microscopy, combining with Transition Matrix calculation, was used to analysis the orientations and electron diffraction patterns of eta' precipitates. It was found that the eta' phases in four variants had only three different zone axis: [2 (4) over bar 23](eta'), [10 (1) over bar0] T and [(2) over tilde4 (2) over bar3](eta'), parallel to the [110](Al) direction of Al matrix when they were precipitated. By integrating the atomic coordinates, structure factors and double diffraction effect, a new diffraction patterns model under the [110](Al) zone axis was established, which was good in agreement with the experimental result. Simultaneously, Moire fringes analytical technique was also used to quantitatively verify the lattice parameters and orientation variants of eta' precipitates, and demonstrated that Moire fringes with about 0.7 nm spacing were the results of the interaction between the 0004(eta')/4000 (4) over bar (eta'), diffraction eta' of Ti' precipitates in variants 3/4 under the [10 (1) over bar0] y zone axis and the 1 (1) over bar (Al)/1 (1) over bar(1) over bar (Al) of Al matrix under the [110](Al) zone axis. Furthermore, the high-resolution transmission electron microscopy image simulation for Moire fringes of eta' precipitates in the Al matrix presented a good match with the experimental result. (C) 2014 Elsevier B.V. All rights reserved.

Atomic-scale study on the precipitation behavior of an Al-Zn-Mg-Cu alloy during isochronal aging

Quantitative Evaluation of Precipitates in an Al–Zn–Mg–Cu Alloy after Isothermal Aging

Microscopic phase-field study on aging behavior of Ni75Al17Zn8 alloy

Precipitation in an Al-Zn-Mg-Cu alloy during isothermal aging: Atomic-scale HAADF-STEM investigation

Microscopic Phase-Field Simulation for Precipitation Behavior of Ni-Al-Cr Alloy During Two-Step Aging

Precipitation Sequence of Η Phase along Low-Angle Grain Boundaries in Al-Zn-Mg-Cu Alloy During Artificial Aging

Initial Precipitation and Hardening Mechanism During Non-Isothermal Aging in an Al–Mg–Si–Cu 6005A Alloy

Small-angle X-ray Scattering Study of Precipitates in AlZnMgCu-1.0 Wt.% Li Alloy

Precipitation behavior of an Al–Cu–Li–X alloy and competing relationships among precipitates at different aging temperatures

Small Angle X-Ray Scattering Study on Microstructure Evolution of the Aging Process of Al-Zn-Mg-Cu-Li Alloy

Precipitation and aging phenomena in an ultrafine grained Al-Zn alloy by severe plastic deformation

Nucleation and evolution mechanism of precipitates during the initial aging stage in Al-Zn-Mg-Cu alloy

Effect of Ageing Temperature on Precipitation of Al-Cu-Li-Mn-Zr Alloy

Characterization of Precipitates in an Aged 7xxx Series Al Alloy

Precipitation Behaviour of Al–Zn–Mg–Cu Alloy and Diffraction Analysis from Η′ Precipitates in Four Variants

Effect of Over-Aging Degree on Microstructures, Precipitation Kinetics, and Mechanical Properties of an Ultra-High-Strength Al-Zn-Mg-Cu Alloy

Early-stage Clustering and Precipitation Behavior in the Age-Hardened Al–Mg–Zn(-Cu) Alloys

Early-stage precipitation in Al?Zn?Mg?Cu alloy (7050)

Characterization of Precipitation in Al-Zn-Mg-Cuand Li Containing Al-Zn-Mg-Cu Alloys after Isothermal Aging

Effect of Non-Isothermal Aging on Microstructure and Properties of Al–5.87Zn–2.07Mg–2.42Cu Alloys

Study on Aging Precipitation Characteristic of High Strength Al-Zn-Mg-Cu Alloy