Abstract:This paper has explored an ultra-low-power design of two 60-GHz direct-conversion receivers in a 65-nm CMOS process for single-channel and multi-channel applications under the IEEE 802.15.3c standard, respectively. One subthreshold biasing 0.4-V transconductance mixer is designed with a compact quadrature hybrid coupler (160 μm × 210 μm with measured 3-dB intrinsic loss) in receivers to achieve low power (8 mW for single channel and 12.4 mW for multi-channel) and high gain (55 dB for single channel and 62-dB for multi-channel). One three-stage low-noise amplifier employs high- Q passive matchings. A double-layer-stacked inductor is utilized for matching in the single-channel receiver and a high-impedance transmission line is utilized for matching in the multi-channel receiver, respectively. In addition, one new modified Cherry-Hooper amplifier is applied for the variable-gain amplifier design to achieve high gain-bandwidth product and high power efficiency. The single-channel receiver is implemented with 0.34- mm2 chip area. It is measured with a power consumption of 8 mW, a minimum single-sideband noise figure (NF) of 4.9 dB, a 3-dB bandwidth of 3.5 GHz, and a maximum conversion gain of 55 dB. The multi-channel receiver is implemented with 0.56- mm2 chip area. It is measured with a power consumption of 12.4 mW, a 3-dB bandwidth of 8 GHz (59.5 ~ 67.5 GHz), and a maximum conversion gain of 62 dB. The measurement results show that the two demonstrated 60-GHz direct-conversion receivers can achieve high gain and low NF with ultra-low power in 65-nm CMOS.

Research of Fully Integrated CMOS SCA Receiver

A C-Band Four-Channel Receiver with Current-Sharing and Large-Signal Multigated-Transistor Techniques in 65-Nm CMOS

A 100mhz-2ghz Wireless Receiver In 40-Nm Cmos For Software-Defined Radio

A Sub-GHz CMOS Low-IF Receiver for Lot Applications

A 14-Bit 500-Ms/S Sha-Less Pipelined Adc In 65nm Cmos Technology For Wireless Receiver

A 0.5-8Ghz Reconfigurable CMOS RF Receiver Front-end for CR and DPA Applications

A 144 GHz 2.5mW multi-stage regenerative receiver for mm-Wave imaging in 65nm CMOS

A Fully Integrated CMOS Transceiver for Mobile UHF RFID Reader

A 28-/60-GHz Dual-Band Receiver Front-End With Sideband-Selection Technique in 65-nm CMOS

A CMOS Analog Integrated Front End for L Band DAB Receiver

A Fully Integrated 60ghz Four Channel CMOS Receiver with 7ghz Ultra-Wide Bandwidth for IEEE 802.11ad Standard

Wireless Receiver Architectures for Soc

A Fully Integrated CMOS 60-Ghz Transceiver for IEEE802.11ad Applications.

A Fully Integrated Reconfigurable Low-Power Sub-GHz Transceiver for 802.11ah in 65nm CMOS

A Fully-Integrated Reconfigurable Dual-Band Transceiver for Short Range Wireless Communications in 180 Nm CMOS.

A Low-Power Reconfigurable Multi-Band Sliding-If Transceiver For Wban Hubs In 0.18 Mu M Cmos

Development of an optoelectronic integrated circuit for indoor optical wireless communication systems

A Ka-Band Two-Channel Two-Beam Receiver Based on a Substrate-Integrated Suspended Line

A Reconfigurable IF Receiver Supporting Intra-Band Non-Contiguous Carrier Aggregation in 65 Nm CMOS.

A Low Noise, High Linearity CMOS Receiver for 802. 11b WLAN Applications

Design of Ultra-Low-Power 60-Ghz Direct-Conversion Receivers in 65-Nm CMOS