Abstract:This article presents a 17.720.2 GHz eight-element four-beam RF-beamforming transmitter in 65-nm CMOS for satellite communication (SATCOM). The transmitter utilizes an analog scheme in the variable-gain amplifier (VGA) to achieve dB-in-linear gain control with a high dynamic range (DR), together with a current combining crossbar for a compact footprint. The vector-modulation-based (VM-based) phase shifter (PS) adopts the cancellation-based $G_\mathrm{m}$ units for low switching variation. Furthermore, eight PSs of each beam are split into two groups, with each group sharing the same tunable I/Q generator for low power consumption. Considering the increased peak-to-average power ratio (PAPR) caused by high-order modulation schemes and multibeam operation, the transmitter incorporates compact transformer-based Doherty power amplifiers (DPAs) with adaptive bias control to improve the power efficiency at back-off. The chip achieves a 31-dB gain-tuning range with a 0.283-dB step and a 360 $^{\circ}$ phase-shifting range with a calibrated 7-bit resolution. The measured root-mean-square (RMS) phase/gain errors induced by the VGA/PS are below 2.05 $^{\circ}$ /0.147 dB, respectively, which decouples phase/gain control. The transmitter achieves a maximum output 1-dB gain compression point (OP $_{\mathrm{1 dB}}$ ) of 17.9 dBm and a maximum saturated power ( $P_{\mathrm{sat}}$ ) of 18.9 dBm. The output element exhibits 29.3% drain efficiency (DE) at 6-dB power back off (PBO) from $P_{\mathrm{sat}}$ , which is 1.56/3.12 times over the normalized class-B/class-A implementations, demonstrating Doherty PBO efficiency enhancement. The chip occupies an area of 8.59 $\times$ 4.17 mm $^2$ and consumes 398 mW per element at OP $_{\mathrm{1~dB}}$ . Additionally, a 16-element linear array has been developed to showcase the capabilities of the multibeam operation and gain tapering.

A Ka-Band Two-Channel Two-Beam Receiver Based on a Substrate-Integrated Suspended Line

A Compact Ka-Band Eight-Element Four-Beam Receiver for Low-Earth-Orbit Satellite Communications in 65-Nm CMOS

A Ka-Band 64-Element Four-Beam Phased Array Receiver with Inter-Beam Interference Cancellation

A $C$ -Band Slat-Type Phased-Array Receiver with Co-Aperture Concurrent Eight Beams

A C-Band Compact High-Linearity Multibeam Phased-Array Receiver With Merged Gain-Programmable Phase Shifter Technique

A K-Band 4-Element 8-Beam Phased-Array Receiver with Hybrid Vector Interpolation and Impedance-Adapted Multibeam Combining Techniques for Satellite Communications

Design of a 64-Element Dual-Polarized Planar Receive Phased Array with Four Concurrent Reconfigurable Beams for Ka-Band SATCOM

A Four-Element 7.5–9-Ghz Phased-Array Receiver with 1–8 Simultaneously Reconfigurable Beams in 65-Nm CMOS

The Design of a K-Band 256-Element Reconfigurable Multi-Beam Phased-Array for SATCOM Application

A $K$-Band Four-Beam Transmitter with Decoupled Phase/Gain Control and Enhanced Power Back off Efficiency for SATCOM

A K-Band Eight-Element Dual-Beam Receiver with Current-Sharing-Based Low-Power Technique for LEO SATCOM in 65-Nm CMOS

A C-Band Four-Channel Receiver with Current-Sharing and Large-Signal Multigated-Transistor Techniques in 65-Nm CMOS

A 4-Element 7.5-9 GHz Phased Array Receiver with 8 Simultaneously Reconfigurable Beams in 65 Nm CMOS Technology

A Low-Power Radiation-Hardened $Ka$-Band CMOS Phased-Array Receiver for Small Satellite Constellation

A 4-Element 4-Beam Ka-Band Phased-Array Receiver Using Mesh Topology in 65 Nm CMOS

Design of a Ka-Band Heterogeneous Integrated T/R Module of Phased Array Antenna

A 4-Element Ka-Band Phased-Array Receiver with Code-Domain Hybrid Beamforming

A Ku-Band 8-Element Phased-Array Transmitter with Built-in-Self-Test Capability

A K‐band eight‐element reconfigurable phased‐array receiver with high Tx‐band rejection

A Ka-Band Deployable Active Phased Array Transmitter Fabricated on 4-Layer Liquid Crystal Polymer Substrate for Small-Satellite Mount

A Ku-Band 8-Element Phased-Array Receiver in 0.18-mu m CMOS Technology