Abstract:This article presents a 17.720.2 GHz eight-element four-beam RF-beamforming transmitter in 65-nm CMOS for satellite communication (SATCOM). The transmitter utilizes an analog scheme in the variable-gain amplifier (VGA) to achieve dB-in-linear gain control with a high dynamic range (DR), together with a current combining crossbar for a compact footprint. The vector-modulation-based (VM-based) phase shifter (PS) adopts the cancellation-based $G_\mathrm{m}$ units for low switching variation. Furthermore, eight PSs of each beam are split into two groups, with each group sharing the same tunable I/Q generator for low power consumption. Considering the increased peak-to-average power ratio (PAPR) caused by high-order modulation schemes and multibeam operation, the transmitter incorporates compact transformer-based Doherty power amplifiers (DPAs) with adaptive bias control to improve the power efficiency at back-off. The chip achieves a 31-dB gain-tuning range with a 0.283-dB step and a 360 $^{\circ}$ phase-shifting range with a calibrated 7-bit resolution. The measured root-mean-square (RMS) phase/gain errors induced by the VGA/PS are below 2.05 $^{\circ}$ /0.147 dB, respectively, which decouples phase/gain control. The transmitter achieves a maximum output 1-dB gain compression point (OP $_{\mathrm{1 dB}}$ ) of 17.9 dBm and a maximum saturated power ( $P_{\mathrm{sat}}$ ) of 18.9 dBm. The output element exhibits 29.3% drain efficiency (DE) at 6-dB power back off (PBO) from $P_{\mathrm{sat}}$ , which is 1.56/3.12 times over the normalized class-B/class-A implementations, demonstrating Doherty PBO efficiency enhancement. The chip occupies an area of 8.59 $\times$ 4.17 mm $^2$ and consumes 398 mW per element at OP $_{\mathrm{1~dB}}$ . Additionally, a 16-element linear array has been developed to showcase the capabilities of the multibeam operation and gain tapering.

Design of a 64-Element Dual-Polarized Planar Receive Phased Array with Four Concurrent Reconfigurable Beams for Ka-Band SATCOM

The Design of a K-Band 256-Element Reconfigurable Multi-Beam Phased-Array for SATCOM Application

A Ka-Band 64-Element Four-Beam Phased Array Receiver with Inter-Beam Interference Cancellation

A K-Band 4-Element 8-Beam Phased-Array Receiver with Hybrid Vector Interpolation and Impedance-Adapted Multibeam Combining Techniques for Satellite Communications

A Compact Ka-Band Eight-Element Four-Beam Receiver for Low-Earth-Orbit Satellite Communications in 65-Nm CMOS

A $C$ -Band Slat-Type Phased-Array Receiver with Co-Aperture Concurrent Eight Beams

A $K$-Band Four-Beam Transmitter with Decoupled Phase/Gain Control and Enhanced Power Back off Efficiency for SATCOM

A K-Band Eight-Element Dual-Beam Receiver with Current-Sharing-Based Low-Power Technique for LEO SATCOM in 65-Nm CMOS

A 1536-Element Ku-Band Dual-Polarized Transmit Phased Array for SATCOM Application

A 4-Element 4-Beam Ka-Band Phased-Array Receiver Using Mesh Topology in 65 Nm CMOS

K-/Ka-Band Planar Shared-Aperture Beam-Scanning Array Antenna for Simultaneous Transmitting and Receiving Low Earth Orbit Satellite Communication Terminal

Compact Shared-Aperture Dual-Band Dual-Circularly-Polarized Waveguide Antenna Array Operating at K/Ka-Band

Wideband Dual Circularly Polarized Beam-Scanning Array For Ka-Band Satellite Communications

A Multipolarized Planar Phased Array for LEO SATCOM Applications

An Active Receiving Phased Array for Satellite Communication in K Band

Design of Polarization-Reconfigurable Beam-Scanning Monopulse Phased Array

A Planar Dual Polarized Shared-Aperture Array for K-/Ka-band Satcom Application

A 17.7-21.2 GHz Antenna Element for SATCOM Phased-Array Receiver

Wideband Simultaneous Dual Circularly Polarized Phased Array Subarray with Scalable Characteristics for Satellite Communications

A Ka-Band Balanced Four-Beam Phased-Array Receiver with Symmetrical Beam-Distribution Network in 65-Nm CMOS

K/Ka-Band 4-Element 4-Beam Hybrid Phased-Array Transmitter and Receiver Front-Ends with Compact Layout Floor-Plans and Fault-Tolerant Digital Circuits