Abstract:We present a 24–30-GHz 256-element dual-polarization transceiver (TRX) phased array based on a 16-element beamformer integrated circuit (BF-IC), 2-element frequency conversion integrated circuit (FC-IC), liquid crystal polymer (LCP)-based combiners and filters, and a tileable package with 64 embedded dual-polarized (dual-pol) antennas. The phased array presented in this work overcomes three key challenges in current 5G millimeter-wave (mmWave) antenna arrays: 1) it supports a dramatic increase in the number of supported fast-access beams; 2) it offers improved power efficiency; and 3) it provides a path to lower solution cost. 1) We enable fast switching among 30 000 beams—orders of magnitude improvement over prior work—by employing an on-chip beam calculator in the BF-IC, achieving 200-ns beam setup and 8-ns over-the-air (OTA)-switching time. 2) We enable a module-level transmitter (TX) mode peak power added efficiency (PAE) of 20% using a modular architecture that preserves power amplifier (PA) linearity and efficiency as well as receiver (RX) mode low noise amplifier (LNA) noise figure (NF). The module achieves Psat effective isotropically radiated power (EIRP) of 68.5 dBm and BF-IC NF 3.9 dB. 3) We lower the solution cost by enabling a wider steering range to reduce the number of phased arrays required in a sectorized coverage scheme, by reducing the IC and package area, and by avoiding calibration. The wider steering range is enabled by using an in-package magnetoelectric dipole antenna (for the first time in silicon-based phased arrays), resulting in steering over 70 in H-and V-pol in both E-and H-planes without requiring any calibration. Moreover, the module achieves 20-dB cross-polarization isolation across the entire 70 beam steering range.

A 4-Element 4-Beam Ka-Band Phased-Array Receiver Using Mesh Topology in 65 Nm CMOS

A Ka-Band 64-Element Four-Beam Phased Array Receiver with Inter-Beam Interference Cancellation

A 4-Element 7.5-9 GHz Phased Array Receiver with 8 Simultaneously Reconfigurable Beams in 65 Nm CMOS Technology

A Four-Element 7.5–9-Ghz Phased-Array Receiver with 1–8 Simultaneously Reconfigurable Beams in 65-Nm CMOS

Design of a 64-Element Dual-Polarized Planar Receive Phased Array with Four Concurrent Reconfigurable Beams for Ka-Band SATCOM

A K-Band 4-Element 8-Beam Phased-Array Receiver with Hybrid Vector Interpolation and Impedance-Adapted Multibeam Combining Techniques for Satellite Communications

A $C$ -Band Slat-Type Phased-Array Receiver with Co-Aperture Concurrent Eight Beams

A Compact Ka-Band Eight-Element Four-Beam Receiver for Low-Earth-Orbit Satellite Communications in 65-Nm CMOS

A C-Band Compact High-Linearity Multibeam Phased-Array Receiver With Merged Gain-Programmable Phase Shifter Technique

The Design of a K-Band 256-Element Reconfigurable Multi-Beam Phased-Array for SATCOM Application

Steerable Simultaneous Multibeam Antenna Based on Reconfigurable Reflectarray

A K-Band Eight-Element Dual-Beam Receiver with Current-Sharing-Based Low-Power Technique for LEO SATCOM in 65-Nm CMOS

A 4-Element Ka-Band Phased-Array Receiver with Code-Domain Hybrid Beamforming

A 26.9-Ghz 4-Element Code-Domain Hybrid Beamforming Phased-Array Receiver

A 4-Element 60-Ghz CMOS Phased-Array Receiver with Transformer-Based Hybrid-Mode Mixing and Closed-Loop Beam-Forming Calibration

An mmWave FZP-Based Phased Array

A Ku Band 4-Element Phased Array Transceiver in 180 Nm CMOS

An Integrated Optical Beamforming Network for Two-Dimensional Phased Array Radar

Lower Sidelobe Phased Array Based on Pattern Reconfigurable Elements

A 24–30-GHz 256-Element Dual-Polarized 5G Phased Array Using Fast On-Chip Beam Calculators and Magnetoelectric Dipole Antennas