A Low-Power Radiation-Hardened $Ka$-Band CMOS Phased-Array Receiver for Small Satellite Constellation

Xi Fu,Dongwon You,Yun Wang,Xiaolin Wang,Ashibir Aviat Fadila,Chenxin Liu,Sena Kato,Chun Wang,Zheng Li,Jian Pang,Atsushi Shirane,Kenichi Okada
DOI: https://doi.org/10.1109/jssc.2023.3308562
IF: 5.4
2023-01-01
IEEE Journal of Solid-State Circuits
Abstract:This article introduces a low-power radiation-hardened $Ka$ -band CMOS phased-array receiver for the low Earth orbit (LEO) small satellite communication system. As the available solar panel area limits the power consumption of the receiver, a multi-coupling common-gate (CG) low noise amplifier (LNA) with current-sharing topology and built-in 180 $^\circ$ phase shifter is proposed in this work to solve the power issue. The multi-coupling LNA utilizes three coupling inductors to reduce the input matching impedance with a smaller input CMOS transistor size. After implementing the proposed technique, a single beamformer realized a 3.4-mW typical power consumption compared with the conventional works with 17.3–195-mW power consumption. The receiver with magnetic-tuning phase shifter (MTPS) has 0.06-dB/Mrad gain and 0.4 $^\circ$ /Mrad phase degradations and is the lowest reported root-mean-square phase and gain errors due to radiation. The proposed receiver achieves $-$ 22-dBm IIP3 with a 3.8-dB noise figure. The required on-chip area for each element is only 0.2 mm $^2$ . In the over-the-air (OTA) measurement, digital video broadcasting-second generation extension (DVB-S2x) standard modulated signals of up to 256 amplitude phase shift keying (APSK) can be supported by the proposed large array modules. This work realizes $-$ 33.2-dB error vector magnitude (EVM) and 12.8-Gb/s link speed with 1.6-GHz channel bandwidth. The measured beam pattern can cover radiated angle from $-$ 50 $^\circ$ to $+$ 50 $^\circ$ with lower than $-$ 10-dBc sidelobe level. Because of the proposed multi-coupling LNA and MTPS, a low-power radiation-hardened phased-array receiver for small LEO satellites can be achieved in this work.
engineering, electrical & electronic
What problem does this paper attempt to address?