Abstract:Three RF switches and a phase shifter are proposed using the conductive bridging random access memory (CBRAM) technique. The fabrication process is developed with the Nafion membrane on a high-resistivity silicon substrate. The equivalent circuit model is established for each memristive RF switch. The proposed switches and the phase shifter have been validated by the good agreement achieved among the simulated, measured, and modeled results. The experimental results show that the series planar switch has the ON-state insertion loss (IL) below 1.69 dB and the OFF-state isolation over 25 dB up to 10 GHz, with the actuation voltages of 6.1~7.8/−1.5~−2 V. The parallel metal–insulator–metal (MIM) switch has the small ON-state IL below 0.45 dB and the OFF-state isolation over 18.4 dB when biased with 0.8~3.7/−0.5~−0.9 V. The series MIM switch has the ON-state IL below 0.61 dB and the OFF-state isolation over 21.9 dB with 0.7~2.3/−0.5~−0.9 V. The series MIM switch shows a good comprehensive performance of low actuation voltage, good uniformity, low IL, moderate isolation, and independent control. The phase shifter is realized with four series MIM switches, which provides a phase shift of 45° ± 5° from 3.8 to 4.3 GHz with the in-band IL of 2.25 dB. Compared with the conventional RF switchable devices, the proposed devices have the advantages of nonvolatility and low power consumption. Without depending on the electron beam lithography process and high-temperature phase change, the proposed technique is promising for reconfigurable RF circuits with mass production and feasibility to various substrates.

RF model of flexible microwave switches employing single-crystal silicon nanomembranes on a plastic substrate

RF model of flexible microwave single-crystalline silicon nanomembrane PIN diodes on plastic substrate

Influence of Bending Strains on Radio Frequency Characteristics of Flexible Microwave Switches Using Single-Crystal Silicon Nanomembranes on Plastic Substrate

Experimental Characterization and Modeling of the Bending Strain Effect on Flexible Microwave Diodes and Switches on Plastic Substrate

Design of A Novel Bulk Micro-Machined Rf Mems Switch

Research of Microwave Transmission Properties of Series and Shunt RF MEMS Switch

Fabrication and Characterization of Flexible Microwave Single-Crystal Germanium Nanomembrane Diodes on a Plastic Substrate

Flexible Radio-Frequency Micro Electro-Mechanical Switch Towards the Applications of Satellite Communications

Stress Suppression Design for Radiofrequency Microelectromechanical System Switch Based on a Flexible Substrate

An Analytical Model for High Performance Capacitive RF MEMS Switch Design

Status overview: Fabrication, characterization and modeling of flexible RF/microwave nanoelectronics

Silicon-based Flexible-Grid Mode- and Wavelength-Selective Switch Utilizing Microring Resonators and Y-junctions

Flexible-Grid Wavelength-Selective Switch Based on Silicon Microring Resonators with Interferometric Couplers

Conductive Bridging-Based Memristive RF Switches on a Silicon Substrate

Experimental Demonstration of a Flexible-Grid 1×2 Wavelength-Selective Switch Based on Silicon Microring Resonators.

Impact of Strain on Radio Frequency Characteristics of Flexible Microwave Single-Crystalline Silicon Nanomembrane P-Intrinsic-N Diodes on Plastic Substrates

High-Performance Flexible Single-Crystalline Silicon Nanomembrane Thin-Film Transistors with High- k Nb 2 O 5 -Bi 2 O 3 -MgO Ceramics as Gate Dielectric on a Plastic Substrate.

Multi-Physical Models of Bending Characteristics on the Double-Clamped Beam Switch for Flexible Electronic Devices Application

Capacitive Rf MEMS Switch with Composite Beam

Nonlinear Modeling of RF Switch Based on COMSOL Parameter Extraction

Investigation of Various Mechanical Bending Strains on Characteristics of Flexible Monocrystalline Silicon Nanomembrane Diodes on a Plastic Substrate