Abstract:The single pole-to-ground (SPG) fault is one of critical failures which will have a serious impact on the stable operation of the multi-terminal DC distribution network based on the modular multilevel converter (MMC). It is very significant to analyze fault characteristics for detecting faults and protection design. This paper established the DC SPG fault model, which showed that in the presence of a reactor, the short-circuit current was reduced from 2.3 kA to 1 kA at 6 ms after the fault. Then, a novel SPG fault protection strategy was proposed, which detected the current derivative in connection transformer grounding branch. When the value increases past the threshold of current derivative, small resistance was switched on to increase fault current. Thus, the reliability of differential protection was enhanced. Compared with the traditional protection method, the proposed method does not need communication, and improved the speed of protection. Finally, the simulation model was established in PSCAD/EMTDC. The model included three converter stations: T1, T2 and T3. Among them, T1 outputs power, and T2 and T3 receive power. The results of RTDS showed that the DC circuit breaker operated within 3 ms, the three-port circuit breaker worked within 50 ms, which proves that the proposed strategy was effective. At this time, the system switched from the T1–T2–T3 three-terminal networking operation mode to the T1–T2 two-terminal hand-in-hand operation mode. Since the T3 terminal no longer received power, the transmission power of the T1 terminal decreased, and the received power of the T2 terminal remained unchanged.

A Novel Protection And Control Strategy For High-Voltage Power Frequency Control System

Design And Test Of Unified Power Flow Controller Protection Circuits

A Novel Protection Scheme for LCC-MMC Hybrid Multi-terminal HVDC Transmission Lines

Fault Protection and Control Strategy of Multilevel Voltage-Balancing DC-DC Converter

Study of protection strategy for VSC based HVDC system

A Novel Safe Shutdown Strategy for Matrix Converter Even under Fault Condition

A novel protection scheme for two-phase faults in power distribution system with neutral ungrounded

Failure Protection Strategy of UHVDC Circuit Breaker Under Phase Shift Control

A Local Protection and Local Action Strategy of DC Grid Fault Protection

Research on DC Protection Strategy in Multi-Terminal Hybrid HVDC System

Coordinated Partition Based Protection Strategy for Multi-terminal DC Systems

A Two-Stage Protection Scheme Based on Control and Protection Coordination for AC/DC Hybrid Distribution Network

Analysis of Fault and Protection Strategy of a Converter Station in MMC-HVDC System

A Novel Whole-Line Quick-Action Protection Principle for HVDC Transmission Lines Using One-End Voltage

Protected control strategies for voltage-source-converter (VSC) under grid faults in AC/DC hybrid grid

Research on Fault Control Strategy for Two Terminal Weak Feed Systems Considering Step-Down V/f Control

A Novel Protection Strategy for Single Pole-to-Ground Fault in Multi-Terminal DC Distribution Network

Research on Amplitude Differential Protection Strategy of Hybrid Power Flow Controller

Research on the Control and Protection Device in DC Traction Power Supply System

A Single-End Protection Scheme for Hybrid MMC HVDC Grids Considering the Impacts of the Active Fault Current-Limiting Control

Fault control and line protection strategy for LVDC microgrids based on modified high-frequency-link DC solid state transformer