Abstract:The flexible DC transmission project of renewable energy has become an inevitable development trend for large-scale renewable energy grid connection. Its two-terminal weak feed AC system is often composed of 100 % power electronic power equipment. The fault control strategy is used at both ends of the line to change the fault current characteristics, leading to a decrease in the performance of traditional differential protection. Based on analyzing the adaptability of current differential protection in the two-terminal weak feed AC system under traditional control strategy (TCS), this paper proposed an improved differential protection for two-terminal weak feed AC system considering negative sequence control coordination strategy. Firstly, the fault characteristics of the two terminal weak feed AC systems are analyzed. On this basis, the adaptability of differential protection under TCS is analyzed, and the quantization function that can quantify the operation performance of differential protection is given. Secondly, based on the problem of the traditional negative sequence control strategy, an improved control strategy is introduced and the operation performance of differential protection under the improved control strategy is studied. Finally, an improved differential protection scheme based on the change of current amplitude is proposed. Simulation results show that the proposed protection scheme can resist higher fault impedance(300 Ω) and noise interference(25 dB). In addition, the proposed differential protection scheme is suitable for the protection requirements of the two terminal weak feed AC systems in different scenarios and has higher sensitivity.

Research on Fault Control Strategy for Two Terminal Weak Feed Systems Considering Step-Down V/f Control

Research on an Asymmetric Fault Control Strategy for an AC/AC System Based on a Modular Multilevel Matrix Converter

A Control Strategy for Ground Fault on the AC Side of MMC-HVDC System

Energy-balancing Control Strategy for Modular Multilevel Converters under Submodule Fault Conditions

Control Strategies for LCC-MMC Hybrid DC System Connected to Passive Networks

A Comprehensive Control Method with Model Predictive Function of MMC-HVDC System under Unbalanced Grid Faults

Finite-Level-State Model Predictive Control for Sensorless Three-Phase Four-Arm Modular Multilevel Converter

Control Strategy for VSC-HVDC Transmission System During Unbalanced Fault

Fault-tolerant Control Strategy with Reduced Switching Frequency for Inverter-Based Fault in Open-Winding PMSM System

Control of Modular Multilevel Converter Under Imbalance of AC Power System

Start-stop Control Strategy for UPFC with Fault Current Limiting

Improved Differential Protection for Two-Terminal Weak Feed AC System Considering Negative Sequence Control Coordination Strategy

Capacitance Reduction Control for Sub-module of Modular Multilevel Converter Applied in Wind Power Generation

A Fault-Tolerated Control Strategy for Sub-Module Faults of Modular Multilevel Converters

Control Strategy Research Of Vsc Based Multiterminal Hvdc System

Low Frequency Operation Control Method for Modular Multilevel Converter Based on Improved Arm Current Prediction

Protected control strategies for voltage-source-converter (VSC) under grid faults in AC/DC hybrid grid

Redundancy Fault-tolerated Control Strategy for Sub-module Faults of Modular Multilevel Converters

Control Strategy For Modular Multilevel Converters In Sub-Module Fault State

Fault-ride Through Control Strategy of Multi-terminal High Voltage DC Systems

Fault-tolerant Control for Modular Multilevel Converter Based on Zero-sequence Voltage Injection