Abstract:This paper studies control strategies for an AC/AC system based on a modular multilevel matrix converter (M3C) when an asymmetric fault occurs in the secondary side ac system. Firstly, the operating principle of M3C is briefly introduced and verified by simulation. Then, based on its mathematical model by double αβ0 transformation, the decoupled control strategies for the primary side and secondary side systems are designed. In view of the asymmetric fault condition of the secondary side system, the positive sequence and negative sequence components of voltages and currents are separated and extracted, and then a proportional resonant controller (PR) is used to regulate the positive and negative sequence currents at the same time to realize decoupled current control in the αβ reference frames. The capacitor voltage balancing control, which consists of an inter-subconverter balancing control and an inner-subconverter balancing control, is realized by adjusting four circulating currents. Finally, the proposed control strategy is validated by simulation in the PSCAD/EMTDC software (Manitoba HVDC Research Center, Canada). The result shows that during the period of the BC-phase short-circuit fault occurring in the secondary side system, the whole system can still operate stably and transmit a certain amount of active power, according to their set values. Furthermore, the capacitor voltages are balanced, with a slight increase during the fault period. The simulation results verify the effectiveness of the proposed control strategy.

Redundancy Fault-tolerated Control Strategy for Sub-module Faults of Modular Multilevel Converters

Energy-balancing Control Strategy for Modular Multilevel Converters under Submodule Fault Conditions

A Submodule Fault Ride-Through Strategy for Modular Multilevel Converters with Nearest Level Modulation

Optimized Control Strategy Based on Dynamic Redundancy for the Modular Multilevel Converter

Fault Tolerant Control of MMC with Redundant Submodules Based on Carrier Phase Shift Modulation

Unified Strategy for Fault-Tolerant Operation of MMC with Multiple SMs Failure Based on SMs Grouping Management

Redundancy Protection for Sub-module Faults in Modular Multilevel Converter

Fault-tolerant Design and Control of Modular Multilevel Converter-Based STATCOM

AC and DC Current Hybrid Control Strategy for Modular Multilevel Converter

Fault Detection and Tolerant Control of Open-Circuit Failure in Mmc with Full-Bridge Sub-Modules

The Unified Model and Optimal Operation Analysis for A Modular Multilevel Converter

Fault-tolerant strategy for modular multilevel converter with nearest level modulation in HVDC system

Optimized Modulation Method for the Modular Multilevel Converter with Redundant Sub-Modules under Arm-Asymmetric Operating Conditions

Bridge-Arm Asymmetric Operation Characteristic and Redundant Protection Strategy of Modular Multilevel Converter

Control Strategies for LCC-MMC Hybrid DC System Connected to Passive Networks

A Submodule Fault-Tolerant Operation Scheme of Modular Multilevel Converters Through Novel Cold and Hot Mixed Topology

Finite-Level-State Model Predictive Control for Sensorless Three-Phase Four-Arm Modular Multilevel Converter

A Fault Tolerant Control For Modular Multilevel Converter Under Submodule Fault Conditions

Open-circuit Faults Localization with error elimination for Modular Multilevel Converters under various control modes

The Fault Detection, Localization, and Tolerant Operation of Modular Multilevel Converters with an Insulated Gate Bipolar Transistor (IGBT) Open Circuit Fault

Research on an Asymmetric Fault Control Strategy for an AC/AC System Based on a Modular Multilevel Matrix Converter