Abstract:The modular multilevel converter (MMC) with nearest level modulation (NLM) is widely used in the high voltage applications for low switching frequency and easy implementation. Existing literature has not provided a complete submodule (SM) fault ride-through scheme for MMC with NLM. In this paper, a strategy including fault detection, localization, redundancy, and recovery is proposed to ensure continuous operation of MMC under IGBT open-circuit faults conditions. It only requires a few hardware and software resources. The features of MMC and SMs with three types of failures are studied, respectively. Based on these, the fault detection method is proposed by using a simple hardware circuit, thus high computation complexity is avoided. Since current fault localization schemes are limited to MMC with carrier phase shifted pulse width modulation, this paper further proposes a strategy for MMC with NLM to locate the faulty SM and identify the fault type. After this, the fault redundancy and the proposed fault recovery method are applied to eliminate the fault and then exit the failure state. Therefore, the ability of SM fault ride-through can be realized. Analysis of failure characteristics are verified in simulation. Experimental results based on a single-phase MMC prototype with 11 SMs per arm are presented to demonstrate the validity of the proposed fault ride-through strategy.

Fault Tolerant Control of MMC with Redundant Submodules Based on Carrier Phase Shift Modulation

Energy-balancing Control Strategy for Modular Multilevel Converters under Submodule Fault Conditions

Redundancy Fault-tolerated Control Strategy for Sub-module Faults of Modular Multilevel Converters

Unified Strategy for Fault-Tolerant Operation of MMC with Multiple SMs Failure Based on SMs Grouping Management

A Submodule Fault Ride-Through Strategy for Modular Multilevel Converters with Nearest Level Modulation

A Fault Tolerant Control For Modular Multilevel Converter Under Submodule Fault Conditions

Fault-tolerant Design and Control of Modular Multilevel Converter-Based STATCOM

The Unified Model and Optimal Operation Analysis for A Modular Multilevel Converter

A Novel Submodule Level Fault-Tolerant Approach for MMC With Integrated Scale-Up Architecture

Repetitive Control of Circulating Current in MMC with Asymmetrical Operation of Upper and Lower Arms

Analysis and Control of Three-Phase Modular Multilevel Converters under the Single Arm Fault Condition

An Improved Phase-Shifted Carrier-Based Modulation And Loss Distribution Analysis For Mmc Using Full Bridge Sub-Modules

Fault-tolerant strategy for modular multilevel converter with nearest level modulation in HVDC system

A Submodule Fault-Tolerant Operation Scheme of Modular Multilevel Converters Through Novel Cold and Hot Mixed Topology

Finite-Level-State Model Predictive Control for Sensorless Three-Phase Four-Arm Modular Multilevel Converter

Fault Detection and Tolerant Control of Open-Circuit Failure in Mmc with Full-Bridge Sub-Modules

Multi-Layer Fault-Tolerant Control Of Mmc For Shipboard Mvdc Power System

A Modular Multilevel Converter with Active Power Filter for Submodule Capacitor Voltage Ripples and Power Losses Reduction

Analysis and Control of Modular Multilevel Converters Under Unbalanced Conditions

Introduction, Modeling and Simulation of Modular Multilevel Converter

Optimized Control Strategy Based on Dynamic Redundancy for the Modular Multilevel Converter