Abstract:This paper studies control strategies for an AC/AC system based on a modular multilevel matrix converter (M3C) when an asymmetric fault occurs in the secondary side ac system. Firstly, the operating principle of M3C is briefly introduced and verified by simulation. Then, based on its mathematical model by double αβ0 transformation, the decoupled control strategies for the primary side and secondary side systems are designed. In view of the asymmetric fault condition of the secondary side system, the positive sequence and negative sequence components of voltages and currents are separated and extracted, and then a proportional resonant controller (PR) is used to regulate the positive and negative sequence currents at the same time to realize decoupled current control in the αβ reference frames. The capacitor voltage balancing control, which consists of an inter-subconverter balancing control and an inner-subconverter balancing control, is realized by adjusting four circulating currents. Finally, the proposed control strategy is validated by simulation in the PSCAD/EMTDC software (Manitoba HVDC Research Center, Canada). The result shows that during the period of the BC-phase short-circuit fault occurring in the secondary side system, the whole system can still operate stably and transmit a certain amount of active power, according to their set values. Furthermore, the capacitor voltages are balanced, with a slight increase during the fault period. The simulation results verify the effectiveness of the proposed control strategy.

Bridge-Arm Asymmetric Operation Characteristic and Redundant Protection Strategy of Modular Multilevel Converter

Energy-balancing Control Strategy for Modular Multilevel Converters under Submodule Fault Conditions

Optimized Modulation Method for the Modular Multilevel Converter with Redundant Sub-Modules under Arm-Asymmetric Operating Conditions

Redundancy Fault-tolerated Control Strategy for Sub-module Faults of Modular Multilevel Converters

The Unified Model and Optimal Operation Analysis for A Modular Multilevel Converter

Low Frequency Operation Control Method for Modular Multilevel Converter Based on Improved Arm Current Prediction

A Submodule Fault Ride-Through Strategy for Modular Multilevel Converters with Nearest Level Modulation

Redundancy Protection for Sub-module Faults in Modular Multilevel Converter

Control of Modular Multilevel Converter Under Imbalance of AC Power System

Introduction, Modeling and Simulation of Modular Multilevel Converter

Research on an Asymmetric Fault Control Strategy for an AC/AC System Based on a Modular Multilevel Matrix Converter

Fault-tolerant Design and Control of Modular Multilevel Converter-Based STATCOM

Analysis and Control of Modular Multilevel Converters Under Unbalanced Conditions

Analysis and Control of Three-Phase Modular Multilevel Converters under the Single Arm Fault Condition

Unified Strategy for Fault-Tolerant Operation of MMC with Multiple SMs Failure Based on SMs Grouping Management

Optimized Control Strategy Based on Dynamic Redundancy for the Modular Multilevel Converter

AC and DC Current Hybrid Control Strategy for Modular Multilevel Converter

A Hybrid Modular Multilevel Converter Topology with an Improved Nearest Level Modulation Method

Fault-tolerant strategy for modular multilevel converter with nearest level modulation in HVDC system

Hybrid Multilevel Converters Based on Thyristor Alternate-arms

Design and Operation of A Hybrid Modular Multilevel Converter