Abstract:The modular multilevel converter (MMC) with nearest level modulation (NLM) is widely used in the high voltage applications for low switching frequency and easy implementation. Existing literature has not provided a complete submodule (SM) fault ride-through scheme for MMC with NLM. In this paper, a strategy including fault detection, localization, redundancy, and recovery is proposed to ensure continuous operation of MMC under IGBT open-circuit faults conditions. It only requires a few hardware and software resources. The features of MMC and SMs with three types of failures are studied, respectively. Based on these, the fault detection method is proposed by using a simple hardware circuit, thus high computation complexity is avoided. Since current fault localization schemes are limited to MMC with carrier phase shifted pulse width modulation, this paper further proposes a strategy for MMC with NLM to locate the faulty SM and identify the fault type. After this, the fault redundancy and the proposed fault recovery method are applied to eliminate the fault and then exit the failure state. Therefore, the ability of SM fault ride-through can be realized. Analysis of failure characteristics are verified in simulation. Experimental results based on a single-phase MMC prototype with 11 SMs per arm are presented to demonstrate the validity of the proposed fault ride-through strategy.

Redundancy Protection for Sub-module Faults in Modular Multilevel Converter

Redundancy Fault-tolerated Control Strategy for Sub-module Faults of Modular Multilevel Converters

Energy-balancing Control Strategy for Modular Multilevel Converters under Submodule Fault Conditions

A Submodule Fault Ride-Through Strategy for Modular Multilevel Converters with Nearest Level Modulation

The Unified Model and Optimal Operation Analysis for A Modular Multilevel Converter

Bridge-Arm Asymmetric Operation Characteristic and Redundant Protection Strategy of Modular Multilevel Converter

The Evolution and Variation of Sub-Module Topologies with DC-fault Current Clearing Capability in MMC-HVDC

Unified Strategy for Fault-Tolerant Operation of MMC with Multiple SMs Failure Based on SMs Grouping Management

Fault Tolerant Control of MMC with Redundant Submodules Based on Carrier Phase Shift Modulation

Optimized Control Strategy Based on Dynamic Redundancy for the Modular Multilevel Converter

A Fault Tolerant Control For Modular Multilevel Converter Under Submodule Fault Conditions

Reliability-Centered Maintenance for Modular Multilevel Converter in HVDC Transmission Application

Introduction, Modeling and Simulation of Modular Multilevel Converter

A Rotation-Based Capacitor-Voltage-balancing Method for Modular Multilevel Converters

Practical Submodule Capacitor Sizing For Modular Multilevel Converter Considering Grid Faults

Submodule Open-Circuit Fault Detection For Modular Multilevel Converters Under Light Load Condition With Rearranged Bleeding Resistor Circuit

Optimized Modulation Method for the Modular Multilevel Converter with Redundant Sub-Modules under Arm-Asymmetric Operating Conditions

Fault-tolerant strategy for modular multilevel converter with nearest level modulation in HVDC system

Start/Stop Control of Modular Multilevel Converter Based HVDC Transmission System

Reliability Modeling and Analysis of Hybrid MMCs Under Different Redundancy Schemes

Overvoltage Suppression for Modular Multilevel Converter with Switch Open-Circuit Fault