Abstract:The single pole-to-ground (SPG) fault is one of critical failures which will have a serious impact on the stable operation of the multi-terminal DC distribution network based on the modular multilevel converter (MMC). It is very significant to analyze fault characteristics for detecting faults and protection design. This paper established the DC SPG fault model, which showed that in the presence of a reactor, the short-circuit current was reduced from 2.3 kA to 1 kA at 6 ms after the fault. Then, a novel SPG fault protection strategy was proposed, which detected the current derivative in connection transformer grounding branch. When the value increases past the threshold of current derivative, small resistance was switched on to increase fault current. Thus, the reliability of differential protection was enhanced. Compared with the traditional protection method, the proposed method does not need communication, and improved the speed of protection. Finally, the simulation model was established in PSCAD/EMTDC. The model included three converter stations: T1, T2 and T3. Among them, T1 outputs power, and T2 and T3 receive power. The results of RTDS showed that the DC circuit breaker operated within 3 ms, the three-port circuit breaker worked within 50 ms, which proves that the proposed strategy was effective. At this time, the system switched from the T1–T2–T3 three-terminal networking operation mode to the T1–T2 two-terminal hand-in-hand operation mode. Since the T3 terminal no longer received power, the transmission power of the T1 terminal decreased, and the received power of the T2 terminal remained unchanged.

Coordinated Partition Based Protection Strategy for Multi-terminal DC Systems

Zone Partitioning Protection Strategy for DC Systems Incorporating Offshore Wind Farm

A Feasible Coordination Protection Strategy for MMC-MTDC Systems under DC Faults

A Modified DC Fault Protection Scheme for Multi-Terminal HVDC Grid Based on Fault Current Limiters

Research on Protection Coordination Between Flexible DC System and Breaker

A Two-Stage Protection Scheme Based on Control and Protection Coordination for AC/DC Hybrid Distribution Network

Research on DC Protection Strategy in Multi-Terminal Hybrid HVDC System

A Novel Protection Scheme for LCC-MMC Hybrid Multi-terminal HVDC Transmission Lines

A Novel Protection Strategy for Single Pole-to-Ground Fault in Multi-Terminal DC Distribution Network

A Single-Ended Protection for Multi-terminal Flexible DC Distribution System

Protection and Post-Fault Recovery of Large HVDC Networks Using Partitioning and Fast-Acting DC Breakers at Strategic Locations

DC fault analysis and protection design in shunt modular multilevel based MTDC system

Protection Method and Coordination with Dc Circuit Breaker in DC Distribution Power Grid

An Integrated Control and Protection Scheme Based on FBSM-MMC Active Current Limiting Strategy for DC Distribution Network

A Novel Hybrid DC Circuit Breaker for Nodes in Multi-Terminal DC System

DC Fault Analysis and Protection Design in Shunt Modular Multilevel-Based MTDC System

Research on an Asymmetric Fault Control Strategy for an AC/AC System Based on a Modular Multilevel Matrix Converter

Protection and Fault Isolation Scheme for DC Distribution Network Based on Active Current-Limiting Control

A Control and Protection Scheme of Multi-terminal DC Power System for DC Line Fault

Analysis of Fault and Protection Strategy of a Converter Station in MMC-HVDC System

Control Strategies for LCC-MMC Hybrid DC System Connected to Passive Networks