Abstract:The strain after rolling plays an important role in the prediction of the microstructure and properties and plate deformation permeability. So, it is necessary to establish a more accurate theoretical strain model for the rolling process. This paper studies the modeling method of the equivalent strain based on the upper bound principle and the stream function method. The rolling deformation region is divided into three zones (inlet rigid zone, plastic zone, and outlet rigid zone) according to the kinematics. The boundary conditions of adjacent deformation zones are modified according to the characteristics of each deformation zone. A near-real kinematics admissible velocity field is established by the stream function method on this basis. The geometric boundary conditions of the deformation region are obtained. The deformation power, friction power, and velocity discontinuous power are calculated according to the redefined geometric boundary conditions. On this basis, the generalized shear strain rate intensity is calculated according to the minimum energy principle. Finally, the equivalent strain model after rolling is obtained by integrating the generalized shear strain rate in time. The plate rolling experiments of AA1060 and the numerical simulations are carried out with different rolling reductions to verify the analytic model precision of the equivalent strain. The results show that the minimum and the maximum relative equivalent strain deviation between the analytic model and the experiment is 0.52% and 9.96%, respectively. The numerical calculation and experimental results show that the model can accurately calculate the strain along the plate thickness. This model can provide an important reference for the rolling process setup and the microstructure and properties prediction.

Effect of Tension Coiler on Temperature Field among Layers for Hot Strip

Fine analysis of section stress of steel strand

Temperature and stress field coupling analysis for collapse of 72AU2 hot rolled strip

Analysis of flatness and critical crown of hot-rolled strip based on thermal-mechanical coupled residual stress analytical model

A STUDY ON THE STRESS DISTRIBUTION IN COIL WRAPPING AND ITS EFFECT ON FINAL COIL DEFORMATION

Residual stress control of hot-rolled strips during run-out table cooling

Temperature modeling and analysis of transfer bar using hot coil box technology

FEM simulation of thermo-mechanical stress and thermal fatigue life assessment of high-speed steel work rolls during hot strip rolling process

Numerical Simulation of Multi-Pass Hot Rolling of TA1/Q235B Clad Plates

A symplectic analytical approach for thermal-metallurgical coupling problems: A case study of hot-rolled coil cooling

Numerical Evaluation of a High Speed Steel Work Roll During Hot Strip Rolling Process

NONLINEAR THREE-DIMENSIONAL SIMULATION FOR HOT CONTINUOUS ROLLING OF STRIP STEEL

Prediction and analysis of rolling process temperature field for silicon steel in tandem cold rolling

Analytical model of hot-rolled strip residual stress and flatness in run-out table cooling

Prediction of residual stress after cold rolling and coiling processes

THERMOMECHANICAL COUPLED FINITE-ELEMENT MODELLING OF SLAB HOT ROLLING

Numerical Simulation Research on the Temperature Field and Hot Roll Crown Model of Hot Continuous Rolling Mills

Numerical Analysis on Flatness Adjusting Performance of Hot Wide Strip Temper Mill with Small-Diameter Work Rolls

Numerical Simulation and Parameter Design of Strip Cold Rolling Process of 301L Stainless Steel in 20-Roll Mill

The central strain analytical modeling and analysis for the plate rolling process

Coupled Analysis of Temperature and Flow During Twin-Roll Casting of Magnesium Alloy Strip