Abstract:A tailor rolled blank (TRB) is a plate of continuously varying thickness with the advantages of lightweight, high strength, and good surface quality. However, it is required that the roll gap can be adjusted online, and the plate and roll produce large elastic deformation in the TRB manufacturing process. These characteristics make the modeling of the force and deformation parameters more difficult. A new mathematical model of roll separating force in the TRB manufacturing process is established taking into account the feature of deformation in this research. The elastic deformation of the strip and the flattening deformation of the roll are considered in order to improve the prediction accuracy of the results. The roll separating forces of the entrance elastic compression region and the exit elastic recovery region are computed using the generalized Hooke's law. A new velocity field is proposed based on the deformation characteristics of the plastic region and velocity boundary conditions, and the power functionals of the internal deformation, shear, friction, and tension are calculated. The analytical models of force and deformation parameters combined the elastic and plastic deformation regions are obtained through iterative operation, which satisfies the convergence condition of the roll separating force and roll flattening. The roll separating force data obtained by the model in this research are compared with the actual measured values in the laboratory, and the deviation value is small, which proves the computational precision of the present model. Additionally, the variations of the entrance velocity and flow volume per second during the TRB manufacturing process are shown, and the influences of the tension and friction factor on the neutral angle and roll separating force are illustrated.

Effect of the Roller-Height-difference of Tensiometer Loopers on the Precision of Flatness Measurement

1502 Precision Measurement of Vertical Straightness of a Roll Workpiece on an Ultra-Precision Lathe

Numerical Analysis on Flatness Adjusting Performance of Hot Wide Strip Temper Mill with Small-Diameter Work Rolls

Evolution of Residual Stress Based on Curvature Coupling in Multi-Roll Levelling

Elongation Control of the Ultra-Thin Tinplate During Two-Stand Temper Rolling Unsteady Process

Wear Compensation Model Based on the Theory of Archard and Definite Integral Method

Numerical Simulation and Parameter Design of Strip Cold Rolling Process of 301L Stainless Steel in 20-Roll Mill

Effect of Tension Coiler on Temperature Field among Layers for Hot Strip

Research on the generation and control of high-order flatness during the controlling of titanium strip profile by the intermediate taper roll in a 20-high mill

Analytical model of hot-rolled strip residual stress and flatness in run-out table cooling

Analysis of flatness and critical crown of hot-rolled strip based on thermal-mechanical coupled residual stress analytical model

A double-layer optimization model for flatness control of cold rolled strip

An Investigation for the Friction Torque of a Tapered Roller Bearing Considering the Geometric Homogeneity of Rollers

Analysis of the Asymmetrical Rolling of Ultra-Thin Strips Considering Elastic Deformation of the Strips

Mathematical modeling and analysis of the tailor rolled blank manufacturing process

A Numerical Study of the Effects of Roller Paths on Dimensional Precision in Die-Less Spinning of Sheet Metal

Numerical Simulation of Plate Temperature Distribution During Hot Rolling

Research on Taper Tension Control Theory Apply in Material Rolling Up Procedure

Residual stress control of hot-rolled strips during run-out table cooling

Influence of rolling force optimization on thickness accuracy of 20-high cold-rolling mill of silicon steel

Research on quarter-wave control in DP980 steel during cold rolling based on multi-pass simulation