Abstract:A tailor rolled blank (TRB) is a plate of continuously varying thickness with the advantages of lightweight, high strength, and good surface quality. However, it is required that the roll gap can be adjusted online, and the plate and roll produce large elastic deformation in the TRB manufacturing process. These characteristics make the modeling of the force and deformation parameters more difficult. A new mathematical model of roll separating force in the TRB manufacturing process is established taking into account the feature of deformation in this research. The elastic deformation of the strip and the flattening deformation of the roll are considered in order to improve the prediction accuracy of the results. The roll separating forces of the entrance elastic compression region and the exit elastic recovery region are computed using the generalized Hooke's law. A new velocity field is proposed based on the deformation characteristics of the plastic region and velocity boundary conditions, and the power functionals of the internal deformation, shear, friction, and tension are calculated. The analytical models of force and deformation parameters combined the elastic and plastic deformation regions are obtained through iterative operation, which satisfies the convergence condition of the roll separating force and roll flattening. The roll separating force data obtained by the model in this research are compared with the actual measured values in the laboratory, and the deviation value is small, which proves the computational precision of the present model. Additionally, the variations of the entrance velocity and flow volume per second during the TRB manufacturing process are shown, and the influences of the tension and friction factor on the neutral angle and roll separating force are illustrated.

Wear Compensation Model Based on the Theory of Archard and Definite Integral Method

Modeling and simulation of wear for alignment mechanism of large aircraft component

Numerical Analysis on Flatness Adjusting Performance of Hot Wide Strip Temper Mill with Small-Diameter Work Rolls

The central strain analytical modeling and analysis for the plate rolling process

Research on the Prediction of Roll Wear in a Strip Mill

Experimental Analysis and Wear Prediction Model Based on Friction Heat for Dry Sliding Contact

A double-layer optimization model for flatness control of cold rolled strip

Wear-life analysis of deep groove ball bearings based on Archard wear theory

An analytical model of plate rolling force with a simple available velocity field and equal perimeter yield criterion

Analysis of rolling force and layer thickness in bimetal clad rolling

Experimental analysis of the wear coefficient for the rolling linear guide

Effect of the Roller-Height-difference of Tensiometer Loopers on the Precision of Flatness Measurement

Time-variant reliability analysis of angular contact ball bearing considering the coupled effect of rolling contact fatigue damage and wear

ASR Bending Force Mathematical Model for the Same Width Strip Rolling Campaigns in Hot Rolling

Modification methodology of fretting wear in involute spline

Mathematical modeling and analysis of the tailor rolled blank manufacturing process

Research on quarter-wave control in DP980 steel during cold rolling based on multi-pass simulation

Numerical calculation of wear in rolling contact based on the Archard equation: Effect of contact parameters and consideration of uncertainties

Modelling of axial thrust force between rolls in strip mill

Analysis of friction fluctuations mechanism of a preloaded roller linear motion guide based on a new 5-DOF dynamic stiffness model

Analytical model of hot-rolled strip residual stress and flatness in run-out table cooling