Abstract:The wide-width titanium strip cold rolling, as an efficient titanium material processing technology, has been widely concerned. During the cold rolling process, high-order flatness defects occur frequently, seriously restricting the improvement of titanium product quality. To analyze the mechanical deformation behavior of titanium strips during cold rolling, and explore the influence of entrance and exit profile index on the generation of high-order flatness defects. An integrated coupling rolling model of the roll system and the strip has been established based on the FEM method, and the accuracy of the model has been verified using on-site measured data. The research results show that when the taper or coning amount of the first intermediate roll increases, if the entrance profile index remains unchanged, the exit profile index will significantly decrease, and the high-order deflection deformation of the work roll axis will occur, ultimately leading to high-order flatness defects. When using the first intermediate taper roll to control the exit profile index, if the exit profile index remains unchanged, the entrance profile index increases by 10 μm, and the coning amount will increase by 8.3mm. Therefore, a plan based on the optimization of the entrance profile index has been proposed, which takes into account both the profile and the high-order flatness, to achieve a smaller coning amount to meet the exit profile index and decrease the risk of high-order flatness. The industrial test results show that after the implementation of the plan, the occurrence rate of high-order flatness decreased by an average of 34.42%.

A double-layer optimization model for flatness control of cold rolled strip

ANALYSIS AND MODIFICATION OF HYDRAULIC ROLLER BENDING FORCE CONTROL SYSTEM

Elongation Control of the Ultra-Thin Tinplate During Two-Stand Temper Rolling Unsteady Process

Multivariable Optimal Control of the Cold Mill Flatness

Robust Optimal Design for Shape and Gauge Composite Control of Cold Strip Mill

Numerical Analysis on Flatness Adjusting Performance of Hot Wide Strip Temper Mill with Small-Diameter Work Rolls

A novel paradigm of flatness prediction and optimization for strip tandem cold rolling by cloud-edge collaboration

Numerical Simulation and Parameter Design of Strip Cold Rolling Process of 301L Stainless Steel in 20-Roll Mill

A novel deep ensemble reinforcement learning based control method for strip flatness in cold rolling steel industry

Research on the generation and control of high-order flatness during the controlling of titanium strip profile by the intermediate taper roll in a 20-high mill

Influence of rolling force optimization on thickness accuracy of 20-high cold-rolling mill of silicon steel

Residual stress control of hot-rolled strips during run-out table cooling

Adaptive Pass Scheduling for Roughness Control in Cold Rolling

Nash equilibrium-based distributed predictive control strategy for thickness and tension control on tandem cold rolling system

Sag Feedback Based Multi-Roll Coordinating Optimal Control Of A Low-Tension Roll-To-Roll System

Study on quarter-wave control of DP980 steel based on a bending force linear combination strategy

Wear Compensation Model Based on the Theory of Archard and Definite Integral Method

Multi-objective optimal edge-drop control in tandem cold rolling of silicon steel strip

The Optimal Design for the Production of Hot Rolled Strip with “tight Oxide Scale” by Using Multi-objective Optimization

Optimization Design Of A Novel X-Type Six-High Rolling Mill Based On Maximum Roll System Stiffness

Integrated AGC Approach for Balancing the Thickness Dynamic Response and Shape Condition of a Hot Strip Rolling Control System