Abstract:The wide-width titanium strip cold rolling, as an efficient titanium material processing technology, has been widely concerned. During the cold rolling process, high-order flatness defects occur frequently, seriously restricting the improvement of titanium product quality. To analyze the mechanical deformation behavior of titanium strips during cold rolling, and explore the influence of entrance and exit profile index on the generation of high-order flatness defects. An integrated coupling rolling model of the roll system and the strip has been established based on the FEM method, and the accuracy of the model has been verified using on-site measured data. The research results show that when the taper or coning amount of the first intermediate roll increases, if the entrance profile index remains unchanged, the exit profile index will significantly decrease, and the high-order deflection deformation of the work roll axis will occur, ultimately leading to high-order flatness defects. When using the first intermediate taper roll to control the exit profile index, if the exit profile index remains unchanged, the entrance profile index increases by 10 μm, and the coning amount will increase by 8.3mm. Therefore, a plan based on the optimization of the entrance profile index has been proposed, which takes into account both the profile and the high-order flatness, to achieve a smaller coning amount to meet the exit profile index and decrease the risk of high-order flatness. The industrial test results show that after the implementation of the plan, the occurrence rate of high-order flatness decreased by an average of 34.42%.

Research on Taper Tension Control Theory Apply in Material Rolling Up Procedure

The Research of the Tension Control System of Optical Fiber Coil Winding Machine

Elongation Control of the Ultra-Thin Tinplate During Two-Stand Temper Rolling Unsteady Process

Optimal control of tension and thickness for tandem cold rolling process based on receding horizon control

Research on the generation and control of high-order flatness during the controlling of titanium strip profile by the intermediate taper roll in a 20-high mill

Research on variable crown work roll curve design for W-shaped profile control of strips

Design of intermediate roll contour and analysis of regulation ability on strip shape of 18-High mill

Research on roll contour and control strategy for edge drop control of high-strength steel in the cold rolling precision mill

TENSION ANALYSIS OF FILAMENT WINDING PROCESS

Optimization of taper winding tension in roll-to-roll web systems

The Research of Fuzzy Control on Winding Tension

Nash equilibrium-based distributed predictive control strategy for thickness and tension control on tandem cold rolling system

Research on the Mechanism and Processability of Roll Forming

Residual stress control of hot-rolled strips during run-out table cooling

Effect of the choice and adjustment of the technical parameters on the cold rolling of spiral flight

Numerical Simulation and Parameter Design of Strip Cold Rolling Process of 301L Stainless Steel in 20-Roll Mill

Research on Tension Control System Based on Fuzzy Control Algorithm

Tension Control Study in the Finishing Mill of Aluminum Hot Rolling Mills Based on PSO+CMAC

Research on quarter-wave control in DP980 steel during cold rolling based on multi-pass simulation

Calculation method and analysis of residual stress in the strip bending roller straightening process

Numerical Analysis on Flatness Adjusting Performance of Hot Wide Strip Temper Mill with Small-Diameter Work Rolls