Abstract:The residual stress in low-alloy hot-rolled strips seriously affects the use and processing of products. Reducing residual stress is important for improving the product quality of hot-rolled strips. In this paper, the changes in grain size and residual stress of hot-rolled strips under different cooling processes were investigated via thermal simulation experiments and electron backscatter diffraction. It was found that the optimum cooling process solution for single-objective optimization of grain size was a final rolling temperature of 875 °C, a laminar cooling speed of 50 °C/s, and a coiling temperature of 550 °C. When single-objective optimization of residual stress was carried out, the optimal cooling process scheme was 900 °C for final rolling temperature, 20 °C/s for laminar cooling speed, and 625 °C for coiling temperature. The significance of the effect of cooling processes on grain size and residual stress was analyzed based on the extreme deviation of the effect of each cooling process on grain size and residual stress in orthogonal experiments. The results show that the coiling temperature was the most influential factor on grain size and residual stress among the cooling process parameters. The difference was that grain size increased with increasing coiling temperature, and residual stress decreased with increasing coiling temperature. Using both grain size and residual stress as evaluation indicators, a multi-objective optimization of the cooling process for hot-rolled strips was carried out via the gray correlation analysis method. The optimized solution was 875 °C final rolling temperature, 30 °C/s laminar cooling speed, and 625 °C coiling temperature. At this time, the grain size was 4.8 μm, and the KAM (Kernel Average Misorientation) was 0.40°. The grain size under the actual production process scheme was 4.4 μm with a KAM of 0.78°. Compared to the actual production process solution, the multi-objective optimization solution showed little change in grain size, with only a 9% increase and a 49% reduction in KAM. The optimization scheme in this paper could significantly reduce the level of residual stresses while ensuring the fine grain size of hot-rolled strips, thus improving the overall quality of hot-rolled strips.

Temperature and stress field coupling analysis for collapse of 72AU2 hot rolled strip

Fine analysis of section stress of steel strand

Thermo-Mechanical Coupling Computation and Warping Analysis During Controlled-Cooling of X65 Heavy Pipeline-Plate

Effect of Tension Coiler on Temperature Field among Layers for Hot Strip

A symplectic analytical approach for thermal-metallurgical coupling problems: A case study of hot-rolled coil cooling

Numerical Evaluation of a High Speed Steel Work Roll During Hot Strip Rolling Process

Temperature Simulation of Aluminium Alloy Double-Arc Welding Process on Simplified Conditions

FEM simulation of thermo-mechanical stress and thermal fatigue life assessment of high-speed steel work rolls during hot strip rolling process

Residual stress control of hot-rolled strips during run-out table cooling

Analysis of flatness and critical crown of hot-rolled strip based on thermal-mechanical coupled residual stress analytical model

Experimental investigation on the inhomogeneities of transverse microstructure and internal stress of high‐strength low‐alloy hot‐rolled strip

Quenching Stress of Hot-Rolled Seamless Steel Tubes under Different Cooling Intensities Based on Simulation

Multi-Objective Optimization of Low-Alloy Hot-Rolled Strip Cooling Process Based on Gray Correlation Analysis

FEM analysis of stress evolution in twin wire welding of AI alloy

Simulation of Temperature and Stress Fields of 2060Al-Li Alloy in FSW Process

Numerical Simulation of Multi-Pass Hot Rolling of TA1/Q235B Clad Plates

NONLINEAR THREE-DIMENSIONAL SIMULATION FOR HOT CONTINUOUS ROLLING OF STRIP STEEL

Analytical model of hot-rolled strip residual stress and flatness in run-out table cooling

Finite Element Analysis of Temper Rolling Process

Numerical Simulation Of Temperature Field And Residual Stress In Multi-Pass Welds In 2.25cr-1mo-0.25v Steel Plate And Comparison With Experimental Measurements

Prediction and analysis of rolling process temperature field for silicon steel in tandem cold rolling