Abstract:Abstract High-entropy ceramics attract more and more attention in recent years. However, mechanical properties especially strength and fracture toughness for high-entropy ceramics and their composites have not been comprehensively reported. In this work, high-entropy (Ti 0.2 Zr 0.2 Hf 0.2 Nb 0.2 Ta 0.2 )B 2 (HEB) monolithic and its composite containing 20 vol% SiC (HEB–20SiC) are prepared by hot pressing. The addition of SiC not only accelerates the densification process but also refines the microstructure of HEB, resulting in improved mechanical properties. The obtained dense HEB and HEB–20SiC ceramics hot pressed at 1800 °C exhibit four-point flexural strength of 339±17 MPa and 447±45 MPa, and fracture toughness of 3.81±0.40 MPa·m 1/2 and 4.85±0.33 MPa·m 1/2 measured by single-edge notched beam (SENB) technique. Crack deflection and branching by SiC particles is considered to be the main toughening mechanisms for the HEB–20SiC composite. The hardness Hv 0.2 of the sintered HEB and HEB–20SiC ceramics is 23.7±0.7 GPa and 24.8±1.2 GPa, respectively. With the increase of indentation load, the hardness of the sintered ceramics decreases rapidly until the load reaches about 49 N, due to the indentation size effect. Based on the current experimental investigation it can be seen that the room temperature bending strength and fracture toughness of the high-entropy diboride ceramics are within ranges commonly observed in structure ceramics.

High-pressure sintering of full-dense B 6 O ceramic with excellent hardness and fracture toughness

High-pressure Preparation of Bulk Tungsten Material with Near-Full Densification and High Fracture Toughness

Mechanical properties of hot-pressed high-entropy diboride-based ceramics

Microstructure and mechanical properties of pressure‐less sintered B4C–SiC–ZrB2–LaB6 ceramic composites

High hardness and high fracture toughness B4C-diamond ceramics obtained by high-pressure sintering

Densification mechanism, microstructure and mechanical properties of ZrC ceramics prepared by high-pressure spark plasma sintering

Sintering pure polycrystalline boron carbide bulks with enhanced hardness and toughness under high pressure

Strengthening Hf0.95Ta0.05B2 Ceramic With Ultrafine Grains and High-density Dislocations

Extraordinary High-Temperature Mechanical Properties in Binder-Free Nanopolycrystalline WC Ceramic

Densification, microstructure and properties of ultra-high temperature HfB2 ceramics by the spark plasma sintering without any additives

Oscillatory pressure sintering of high entropy (Zr0.2Ta0.2Nb0.2Hf0.2Mo0.2)B2 ceramic

Single-phase W 2 B 5 ceramic enabled remarkable performance via spark plasma sintering-high-frequency (SPS-HF) process

Sintering mechanism of pure B4C ceramic prepared by hot oscillating pressing and with excellent mechanical properties

Structure and mechanical properties of hot-pressed B4C-NdB6 composites

The Study on the Property and the Microstructure of Pressureless Sintered h-BN Ceramics

Ultra-fast high-temperature synthesis and densification of high-entropy diborides and diboride-carbide ceramics

Rapid densification and mechanical properties of ultra-high-pressure sintered transition metal carbide ceramics

Physical and mechanical properties of hexagonal boron nitride ceramic fabricated by pressureless sintering without additive

Spark plasma sintering and hot pressing of ZrB2–SiCW ultra-high temperature ceramics

Microstructure evolution of ultra-fine grained HfC ceramics with high hardness sintered under ultrahigh pressure by plastic deformation densification mechanism