Abstract:SiC, as a representative of the third generation semiconductors, is widely investigated in power devices and sensors. However, ohmic contacts, an important component for signal output of various SiC chips, have always faced challenges with unclear formation mech-anism and difficulty to withstand high temperature. To solve such problems, two sets of NPN-type SiC ohmic contact were prepared, including Ti/TaSi2/Pt and Ni/W. Experimental results show that whether ohmic contact can be formed mainly depends on the contact metal. The alloy phase with lower work function is formed after high temperature annealing, which reduces the height and width of the Schottky barrier. For the prepared SiC ohmic contacts, It was demonstrated that the invasion of oxygen atoms cause contacts failure, and incorporation of barrier layer (Ta-based layer) and effective protective layer (Pt layer) determine whether high temperatures can be tolerated. Finally, piezoresistive 4H-SiC pressure sensor chips with dimensions of 3000 mm x 3000 mm x 200 mm were fabri-cated using the obtained ohmic contacts. Sensor chips output resistance were monitored up to 600 & DEG;C in air to show stability of the ohmic contact. The highly stable and high temperature ohmic contact can be applied in a variety of SiC devices.& COPY; 2023 The Author(s). Published by Elsevier B.V. This is an open access article under the CC BY-NC-ND license (http://creativecommons.org/licenses/by-nc-nd/4.0/).

Experimental Investigation of As Preamorphization Implant on Electrical Property of Ti-Based Silicide Contacts

Investigation of Ultrathin Ni Germanosilicide for Advanced pMOS Contact Metallization

A comparative study of C, N and Xe pre-amorphization implantation processes for improving the thermal stability of NiSi films

Ohmic Contacts on p-Type Al-Implanted 4H-SiC Layers after Different Post-Implantation Annealings

Influence of High Dose As Ion Implantation on Electrical Properties of High Resistivity Silicon

Investigation of Ni/Al/Ti Ohmic Contact on N-Type 4H-Sic

Comparison on Mechanical Properties of Heavily Phosphorus- and Arsenic-Doped Czochralski Silicon Wafers

Searching for Device Processing Compatible Ohmic Contacts to Implanted P-Type 4H-Sic

Schottky Contact Property and Annealing Condition of Titanium Silicides in VLSI

The Ohmic Contact of 4H-Sic Power Devices by Pulse Laser Annealing and Rapid Thermal Annealing

Pre-annealing for improved LPCVD deposited boron-doped poly-Si hole-selective contacts

Electrical Properties Of The Tisi2-Si Transition Region In Contacts: The Influence Of An Interposed Layer Of Nb

Formation Mechanism, Interface Characteristics and the Application of Metal/sic Thin-Film Ohmic Contact after High-Temperature Treatment

Annealing Temperature Dependent Properties for Ni/Ti/W Ohmic Contacts Simultaneously Formed on N- and P-Type 4H-Sic

A method to improve the specific contact resistance of 4H-SiC Ohmic contact through increasing the ratio of sp 2 -carbon

Study of Interface State Density and Effective Oxide Charge in Post-Metallization Annealed SiO/sub 2/-Sic Structures

The Thermal Stability Study and Improvement of 4H-Sic Ohmic Contact

Effect of Ti Doping on the Microstructure and Properties of SiCp/Al Composites by Pressureless Infiltration

Characteristics of Ni-based ohmic contacts on n-type 4H-SiC using different annealing methods

Analysis of Energy Density and Scanning Speed Impacts on Ni/Sic Ohmic Contacts During Laser Annealing

Annealing Process Influence And Dopant-Silicide Interaction In Self-Aligned Nisi Technology