Abstract:The rapid advancement of 3D concrete printing (3DCP) and the development of relevant cementitious material compositions can be seen in the last few decades. The commonly used 3DCP method is to build the structure layer by layer after extruding the material through a nozzle. Initially, the pumping and extrusion of the material should be done with considerable fluidity and workability. The extruded layers should retain their shape immediately after extruding and depositing. While constructing the structure in a layerwise manner, the bottom layers should have enough early age strength to support the layers at the top. Therefore, at different processes in 3DCP, the rheological requirement is contradictory. As the rheology of the material is the deterministic factor which decides the fluidity or workability of the mix, proper rheological characterization should be completed accurately. In some instances, due to the higher stiffness, and higher time and rate-dependent material behavior (thixotropic behavior) compared to the conventional concrete, standard rheology measurement techniques have many limitations when used for 3DCP material. Therefore, non-conventional and novel techniques can be implemented with suitable material models to characterize the rheology of 3DCP material. In this study, a comprehensive review was conducted on conventional and non-conventional methods used for characterizing the rheological parameters for 3DCP material. The previously conducted studies were highlighted with the targeted 3DCP processes in the study (if applicable), and rheological parameters achieved from the test (i.e., yield stress, viscosity, and thixotropy). In addition, some experimental studies were conducted to compare several selected testing methods. The rheological parameters achieved from different test methods were compared to identify the similarities, dissimilarities, pros, and cons between the test methods. Furthermore, the extrudability and buildability studies were conducted for the mixes to demonstrate the usage of the mixes in 3DCP applications and to correlate the achieved rheological parameters with these processes.

Study on criticality of coarse aggregate content on early-age properties of 3D printable concrete

Investigation of the Internal Structure of Hardened 3D-Printed Concrete by X-CT Scanning and Its Influence on the Mechanical Performance.

High-strain Rate Compressive Behavior of Concrete Made with Substituted Coarse Aggregates: Recycled Crushed Concrete and Clay Bricks

Bond shear performances and constitutive model of interfaces between vertical and horizontal filaments of 3D printed concrete

Properties and Microstructures of 3D Printable Sulphoaluminate Cement Concrete Containing Industrial By-Products and Nano Clay

Comprehensive investigations on the relationship between the 3D concrete printing failure criterion and properties of fresh-state cementitious materials

Influence of pore defects on the hardened properties of 3D printed concrete with coarse aggregate

Experimental investigation on the effect of coarse aggregate size and silica fume dosage to the fracture parameters of concrete

A review of 3D printed concrete: Performance requirements, testing measurements and mix design

Rheological characterization of ultra-high performance concrete for 3D printing

Incorporating coarse aggregates into 3D concrete printing from mixture design and process control to structural behaviours and practical applications: a review

Rheometry for Concrete 3D Printing: A Review and an Experimental Comparison

Effect of sand gradations on the fresh properties of 3D printable concrete

Characterization of Rheological and Mechanical Properties of Self-Compacting Concrete with Indian Standard Gradation and Particle Packing Gradations

Aggregate-bed 3D concrete printing with cement paste binder

Assessing the Load-Bearing Capacity of 3D-Printed Concrete at Early Ages: An Innovative Approach

Mitigating early age cracking in 3D printed concrete using fibres, superabsorbent polymers, shrinkage reducing admixtures, B-CSA cement and curing measures

Testing Mortars for 3D Printing: Correlation with Rheological Behavior

Assessment of asymmetrical rheological behavior of cementitious material for 3D printing application

Hardened properties of 3D printed concrete with recycled coarse aggregate

Study of 3D printed concrete with low-carbon cementitious materials based on its rheological properties and mechanical performances