Abstract:Construction three-dimensional (3D) printing is an emerging technology within the area of Additive Construction and has the potential of revolutionizing the construction industry and the structural engineering discipline through construction automation. One of the major challenges in construction 3D printing is the lack of understanding of the response of 3D printed elements as well as the lack of design methodologies for such elements. This study proposes a 3D printed concrete (3DPC) wall design, termed RC-framed 3DPC wall, for applications in the seismic force resisting system of low-rise 3DPC buildings. The proposed 3DPC wall is reinforced by an internal reinforced concrete frame that strengthens the 3DPC wall similarly to boundary elements in masonry walls. The proposed 3DPC wall further includes bed-joint reinforcement that provides strength against shear demands and provides stability during printing. This study further discusses connection strategies of the proposed 3DPC wall to roof slabs and the foundation, and, following a limit states approach, formulates strength capacity equations for different in-plane failure mechanisms. In lack of experimental data, the strength equations are validated through finite element analyses as well as through experimental data on concrete block masonry (CBM) walls, with which 3DPC walls bear similarities in terms of the construction approach and are expected to share similar response mechanisms. Comparisons with experimental data were conducted for 16 partially grouted (PG) CBM walls and for 10 confined CBM walls. Comparisons with finite element analysis predictions were conducted for 96 3DPC walls, which varied in terms of bed-joint reinforcement, concrete compressive strength , height-to-length ratio, layer width, and cross-section infill pattern. These comparisons focused on predictions of strength and failure mechanisms. It was observed that the proposed strength design equations could predict the mechanical strength and failure mechanism of 3DPC walls with reasonable accuracy, thus, paving the way to 3DPC building design.

Assessing the Load-Bearing Capacity of 3D-Printed Concrete at Early Ages: An Innovative Approach

Investigation of the Internal Structure of Hardened 3D-Printed Concrete by X-CT Scanning and Its Influence on the Mechanical Performance.

Mechanical behaviors of 3D printed lightweight concrete structure with hollow section

Buildability analysis on squared profile structure in 3D concrete printing (3DCP)

A theoretical model to predict the structural buildability of 3D printable concrete

A discrete lattice model for assessment of buildability performance of 3D‐printed concrete

Analysis and design of 3D printed reinforced concrete walls under in-plane quasi-static loading

Inclined 3D concrete printing: build-up prediction and early-age performance optimization

Strength and Proportioning Design of 3D Printed Concrete (3DPC) Based on Aggregate Gradation Optimization

3D concrete printing: A lower bound analytical model for buildability performance quantification

A review of 3D printed concrete: Performance requirements, testing measurements and mix design

The Influence of Three-Dimensionally Printed Polymer Materials as Trusses and Shell Structures on the Mechanical Properties and Load-Bearing Capacity of Reinforced Concrete

PVA Fibre Reinforced High-Strength Cementitious Composite for 3D Printing: Mechanical Properties and Durability

Peridynamic buildability analysis of 3D-printed concrete including damage, plastic flow and collapse

3D-printing ultra-high performance fiber-reinforced concrete under triaxial confining loads

Triaxial compressive behavior of 3D printed PE fiber-reinforced ultra-high performance concrete

Research on Mechanical Properties of a 3D Concrete Printing Component-Optimized Path by Multimodal Analysis

Mechanical Properties of Structures 3D Printed with Cementitious Powders

3D printing concrete structures: State of the art, challenges, and opportunities

Anisotropic mechanical properties of extrusion-based 3D printed layered concrete

Development of concrete mixes for 3D printing using simple tools and techniques