Abstract:The focus of this study is to determine the load-bearing capacity of a structure produced using 3D printing technology. The main objective is to forecast the highest achievable elevation for 3D-printed concrete construction while avoiding any structural integrity issues. To achieve this objective, an inventive experimental approach was introduced to assess the load-bearing potential of freshly printed concrete. The study involved conducting tests to measure the structure's load-bearing capacity and determine the highest achievable printing height in its initial developmental phase. Afterward, the time-dependent properties were examined experimentally with the intention of integrating them into simulations at a subsequent phase. Subsequently, the buildability standard utilizing the Mohr–Coulomb model was defined, and its accuracy was tested via a combination of numerical and experimental assessments. The model demonstrated satisfactory performance in accurately capturing the time-dependent mechanical behavior of concrete properties as they developed over time. Each casted block weighed 7.2 kg and served as a load on the printed structure. The structure withstood the weight of up to six casted blocks before reaching its failure point, all while achieving a successful printing height exceeding 600 mm. Additionally, the numerical model exhibited satisfactory performance in forecasting the initial plastic bearing capacity of 3DPC during its early stages. However, during the experiments, the actual specimen failed immediately after the application of the sixth load, whereas the modeling results suggested that the specimen could bear the sixth load before ultimately yielding. Ultimately, recommendations were proposed with the goal of enhancing the forthcoming 3DPC simulation modeling.

Inclined 3D concrete printing: build-up prediction and early-age performance optimization

Strength and Proportioning Design of 3D Printed Concrete (3DPC) Based on Aggregate Gradation Optimization

Research on Mechanical Properties of a 3D Concrete Printing Component-Optimized Path by Multimodal Analysis

An integrated topology optimization method including manufacturing constraints for 3D printed fiber-reinforced concrete structures

A review of 3D printed concrete: Performance requirements, testing measurements and mix design

A novel method for improving the printability of cement-based materials: Controlling the releasing of capsules containing chemical admixtures

Assessing the Load-Bearing Capacity of 3D-Printed Concrete at Early Ages: An Innovative Approach

D-optimal design of experiments applied to 3D high-performance concrete printing mix design

Buildability analysis on squared profile structure in 3D concrete printing (3DCP)

Study of 3D printed concrete with low-carbon cementitious materials based on its rheological properties and mechanical performances

Aggregate-bed 3D concrete printing with cement paste binder

On-demand additive manufacturing of functionally graded concrete

3D printing concrete structures: State of the art, challenges, and opportunities

A critical review of preparation design and workability measurement of concrete material for largescale 3D printing

Incorporating coarse aggregates into 3D concrete printing from mixture design and process control to structural behaviours and practical applications: a review

In-process reinforcing method: dual 3D printing procedure for ultra-high performance concrete reinforced cementitious composites

Mechanical Performance of Commercially Available Premix UHPC-Based 3D Printable Concrete

A mechanical characteristic capture method considering printing configurations for buildability modeling in concrete 3D printing

An integrated method of topological optimization and path design for 3D concrete printing

The relationship between the rheological behavior and interlayer bonding properties of 3D printing cementitious materials with the addition of attapulgite

Extrudability window and offline test methods to predict buildability of 3D printing concrete