Abstract:The focus of this study is to determine the load-bearing capacity of a structure produced using 3D printing technology. The main objective is to forecast the highest achievable elevation for 3D-printed concrete construction while avoiding any structural integrity issues. To achieve this objective, an inventive experimental approach was introduced to assess the load-bearing potential of freshly printed concrete. The study involved conducting tests to measure the structure's load-bearing capacity and determine the highest achievable printing height in its initial developmental phase. Afterward, the time-dependent properties were examined experimentally with the intention of integrating them into simulations at a subsequent phase. Subsequently, the buildability standard utilizing the Mohr–Coulomb model was defined, and its accuracy was tested via a combination of numerical and experimental assessments. The model demonstrated satisfactory performance in accurately capturing the time-dependent mechanical behavior of concrete properties as they developed over time. Each casted block weighed 7.2 kg and served as a load on the printed structure. The structure withstood the weight of up to six casted blocks before reaching its failure point, all while achieving a successful printing height exceeding 600 mm. Additionally, the numerical model exhibited satisfactory performance in forecasting the initial plastic bearing capacity of 3DPC during its early stages. However, during the experiments, the actual specimen failed immediately after the application of the sixth load, whereas the modeling results suggested that the specimen could bear the sixth load before ultimately yielding. Ultimately, recommendations were proposed with the goal of enhancing the forthcoming 3DPC simulation modeling.

Extrudability window and offline test methods to predict buildability of 3D printing concrete

Assessment of asymmetrical rheological behavior of cementitious material for 3D printing application

3D Printing of Fiber-Reinforced Calcined Clay-Limestone-Based Cementitious Materials: From Mixture Design to Printability Evaluation

A novel method for improving the printability of cement-based materials: Controlling the releasing of capsules containing chemical admixtures

Printability region for 3D concrete printing using slump and slump flow test

Inclined 3D concrete printing: build-up prediction and early-age performance optimization

The relationship between the rheological behavior and interlayer bonding properties of 3D printing cementitious materials with the addition of attapulgite

Development of concrete mixes for 3D printing using simple tools and techniques

Testing Mortars for 3D Printing: Correlation with Rheological Behavior

Assessing the Load-Bearing Capacity of 3D-Printed Concrete at Early Ages: An Innovative Approach

3D concrete printing: A lower bound analytical model for buildability performance quantification

Investigation of the material mixtures and fiber addition for 3D concrete printing

The evaluation of rheological parameters of 3D printable concretes and the effect of accelerating admixture

Time-dependent fresh properties characterization of 3D printing engineered cementitious composites (3DP-ECC): On the evaluation of buildability

A rheological-based printability assessment method for 3D printing Engineered Cementitious Composites considering fiber dispersion

Damage-rheology model for predicting 3D printed concrete buildability

D-optimal design of experiments applied to 3D high-performance concrete printing mix design

Anisotropic mechanical properties of extrusion-based 3D printed layered concrete

Mechanical behaviors of 3D printed lightweight concrete structure with hollow section

Comparative analysis of structural build-up in one-component stiff and two-component shotcrete-accelerated set-on-demand mixtures for 3D concrete printing

Comprehensive investigations on the relationship between the 3D concrete printing failure criterion and properties of fresh-state cementitious materials