Abstract:The rapid advancement of 3D concrete printing (3DCP) and the development of relevant cementitious material compositions can be seen in the last few decades. The commonly used 3DCP method is to build the structure layer by layer after extruding the material through a nozzle. Initially, the pumping and extrusion of the material should be done with considerable fluidity and workability. The extruded layers should retain their shape immediately after extruding and depositing. While constructing the structure in a layerwise manner, the bottom layers should have enough early age strength to support the layers at the top. Therefore, at different processes in 3DCP, the rheological requirement is contradictory. As the rheology of the material is the deterministic factor which decides the fluidity or workability of the mix, proper rheological characterization should be completed accurately. In some instances, due to the higher stiffness, and higher time and rate-dependent material behavior (thixotropic behavior) compared to the conventional concrete, standard rheology measurement techniques have many limitations when used for 3DCP material. Therefore, non-conventional and novel techniques can be implemented with suitable material models to characterize the rheology of 3DCP material. In this study, a comprehensive review was conducted on conventional and non-conventional methods used for characterizing the rheological parameters for 3DCP material. The previously conducted studies were highlighted with the targeted 3DCP processes in the study (if applicable), and rheological parameters achieved from the test (i.e., yield stress, viscosity, and thixotropy). In addition, some experimental studies were conducted to compare several selected testing methods. The rheological parameters achieved from different test methods were compared to identify the similarities, dissimilarities, pros, and cons between the test methods. Furthermore, the extrudability and buildability studies were conducted for the mixes to demonstrate the usage of the mixes in 3DCP applications and to correlate the achieved rheological parameters with these processes.

Comprehensive investigations on the relationship between the 3D concrete printing failure criterion and properties of fresh-state cementitious materials

Investigation of the Internal Structure of Hardened 3D-Printed Concrete by X-CT Scanning and Its Influence on the Mechanical Performance.

Bond shear performances and constitutive model of interfaces between vertical and horizontal filaments of 3D printed concrete

Time-dependent fresh properties characterization of 3D printing engineered cementitious composites (3DP-ECC): On the evaluation of buildability

3D-printing ultra-high performance fiber-reinforced concrete under triaxial confining loads

Research on Mechanical Properties of a 3D Concrete Printing Component-Optimized Path by Multimodal Analysis

Triaxial compressive behavior of 3D printed PE fiber-reinforced ultra-high performance concrete

Testing Mortars for 3D Printing: Correlation with Rheological Behavior

A mechanical characteristic capture method considering printing configurations for buildability modeling in concrete 3D printing

Failure analysis of 3D concrete printing bolted laminates mimicking geological strata

Influence of pore defects on the hardened properties of 3D printed concrete with coarse aggregate

Assessment of asymmetrical rheological behavior of cementitious material for 3D printing application

Comparative analysis of structural build-up in one-component stiff and two-component shotcrete-accelerated set-on-demand mixtures for 3D concrete printing

The relationship between the rheological behavior and interlayer bonding properties of 3D printing cementitious materials with the addition of attapulgite

Interfacial bonding performance of 3D-printed Ultra-High Performance Strain-Hardening Cementitious Composites (UHP-SHCC) and cast normal concrete

A review of 3D printed concrete: Performance requirements, testing measurements and mix design

A rheological-based printability assessment method for 3D printing Engineered Cementitious Composites considering fiber dispersion

Relationship between microstructure and strain-hardening behaviour of 3D printed engineered cementitious composites

Mechanical Properties of Structures 3D Printed with Cementitious Powders

Rheometry for Concrete 3D Printing: A Review and an Experimental Comparison

A Numerical Study on 3D Printed Cementitious Composites Mixes Subjected to Axial Compression