Abstract:<p>In this work, the lattice model is applied to study the printing process and quantify the buildability (i.e., the maximum height that can be printed) for 3D concrete printing (3DCP). The model simulates structural failure by incorporating an element birth technique, time‐dependent stiffness and strength, printing velocity, non‐uniform gravitational load, localized damage, and spatial variation of the printed object. The model can reproduce the plastic collapse failure modes reported in the literature. In this research, three main contributions for 3DCP modeling work can be found. A new failure criterion is proposed and adopted to improve the estimation of critical printing height; the element birth technique is utilized to mimic the continuous printing process and study the impact of non‐uniform gravitational load; variability of a printed structure is modeled through the inclusion of disorder during mesh generation and Gaussian distributions of material properties. Using this model, parametric analyses on non‐uniform gravitational load and material variation are conducted to assess their impact on the failure–deformation response and the critical printing height. Finally, the model is validated by comparison with two 3D printing experiments from the literature. The proposed lattice model can reproduce the correct failure‐deformation modes of two types of structures commonly used for buildability quantification: A 3D‐printed hollow cylinder and a square wall layout. Lattice modeling of the square structure yields a relative difference of around 10% with the experimental printing height. For the cylinder structure, the predicted radial deformation and corresponding height show good agreement with the experimental data; the model yields a 41.38% overprediction of the total number of printing layers, compared with the experimental data. Possible reasons for the quantitative discrepancy are discussed.</p>

A mechanical characteristic capture method considering printing configurations for buildability modeling in concrete 3D printing

Investigation of the Internal Structure of Hardened 3D-Printed Concrete by X-CT Scanning and Its Influence on the Mechanical Performance.

Bond shear performances and constitutive model of interfaces between vertical and horizontal filaments of 3D printed concrete

Research on Mechanical Properties of a 3D Concrete Printing Component-Optimized Path by Multimodal Analysis

Comprehensive investigations on the relationship between the 3D concrete printing failure criterion and properties of fresh-state cementitious materials

A discrete lattice model for assessment of buildability performance of 3D‐printed concrete

Time-dependent fresh properties characterization of 3D printing engineered cementitious composites (3DP-ECC): On the evaluation of buildability

Inclined 3D concrete printing: build-up prediction and early-age performance optimization

3D concrete printing modelling of thin-walled structures

Assessing the Load-Bearing Capacity of 3D-Printed Concrete at Early Ages: An Innovative Approach

Buildability Analysis of 3D Concrete Printing Process: A Parametric Study Using Design of Experiment Approach

AI-based performance prediction for 3D-printed concrete considering anisotropy and steam curing condition

Failure analysis of 3D concrete printing bolted laminates mimicking geological strata

Modeling concrete deposition via 3D printing using reproducing kernel particle method

Real-time monitoring of extrudability and buildability in 3D concrete printing based on target detection method

Peridynamic buildability analysis of 3D-printed concrete including damage, plastic flow and collapse

A review of recent trends and challenges in numerical modeling of the anisotropic behavior of hardened 3D printed concrete

A theoretical model to predict the structural buildability of 3D printable concrete

3D concrete printing: A lower bound analytical model for buildability performance quantification

Assessing printing synergism in a dual 3D printing system for ultra-high performance concrete in-process reinforced cementitious composite

Interfacial Properties of Three-Dimensional-Printed Permanent Formwork with Cast-in-Place Concrete