Abstract:As we know, 3DPC is printed layer by layer compared with mold-casting conventional concrete. Pore structure and layer-to-layer interface are two main aspects of the internal structure for 3DPC, which decide 3DPC's mechanical performance. The layer-to-layer interface caused by printing is specific to 3DPC. The emphasis of this study lies in the layer-to-layer interfaces of 3DPC. The first aim of this study is to quantify the characteristics of the layer-to-layer interface and therefore characterize different aspects of the interfaces. The second aim of this study is to explore how the internal structure of printed concrete influences the mechanical performance of 3DPC. This research set out to design a series of experimental comparisons between 3DPC and casted concrete with the same compositions. Mechanical tests, i.e., compressive stress, ultrasonic Pulse Velocity test, flexural tension, and tension splitting, as well as the Ultrasonic Pulse Velocity test, were performed to check the mechanical performance of 3DPC. Contrary to what has often been expected, the mechanical test results showed the printed concrete has a quality not worse than casted concrete with the same recipe. Meanwhile, the X-ray computed tomography (X-CT) is used to characterize the internal structure, pore shapes, and interfaces of 3DPC. First, the investigation revealed that the lower total porosity and fewer big voids could be the fundamental causes meaning 3DPC has a better mechanical performance than casted concrete. Second, the statistics based on aspect ratio show that the distribution curves follow similar trends, regardless of the printed or casted concrete. Third, this study quantified the depth of the different interfaces for 3DPC. The results suggest that the porosity in an interface varies in a range. The author's pioneer work has contributed to our present understanding of the interfaces of 3DPC.

Interfacial Properties of Three-Dimensional-Printed Permanent Formwork with Cast-in-Place Concrete

Investigation of the Internal Structure of Hardened 3D-Printed Concrete by X-CT Scanning and Its Influence on the Mechanical Performance.

Interfacial bonding properties of 3D printed permanent formwork with the post-casted concrete

Bond shear performances and constitutive model of interfaces between vertical and horizontal filaments of 3D printed concrete

3D-printed concrete permanent formwork: effect of postcast concrete proportion on interface bonding

Interfacial bonding performance of 3D-printed Ultra-High Performance Strain-Hardening Cementitious Composites (UHP-SHCC) and cast normal concrete

Bonding performance of 3D printing concrete with self-locking interfaces exposed to compression–shear and compression–splitting stresses

Interfacial constitutive model of 3D printed fiber reinforced concrete composites and its experimental validation

Mechanical behaviors of 3D printed lightweight concrete structure with hollow section

Cyclic behavior of unbonded post-tensioned precast segmental concrete columns fabricated by 3D printed concrete permanent formwork

Influence of pore defects on the hardened properties of 3D printed concrete with coarse aggregate

Unbonded interlayer evaluation in freshly 3D printed concrete using electrical resistivity measurements

Triaxial compressive behavior of 3D printed PE fiber-reinforced ultra-high performance concrete

PVA Fibre Reinforced High-Strength Cementitious Composite for 3D Printing: Mechanical Properties and Durability

The relationship between the rheological behavior and interlayer bonding properties of 3D printing cementitious materials with the addition of attapulgite

A critical review of preparation design and workability measurement of concrete material for largescale 3D printing

Experimental and numerical study on the flexural behavior of 3D-printed composite beams with U-shaped ECC formwork

3D printing concrete with recycled coarse aggregates: The influence of pore structure on interlayer adhesion

A mechanical characteristic capture method considering printing configurations for buildability modeling in concrete 3D printing

Bond Performance Between BFRP Bars and 3D Printed Concrete

Mechanical and macrostructural properties of 3D printed concrete dosed with steel fibers under different loading direction