Abstract:As we know, 3DPC is printed layer by layer compared with mold-casting conventional concrete. Pore structure and layer-to-layer interface are two main aspects of the internal structure for 3DPC, which decide 3DPC's mechanical performance. The layer-to-layer interface caused by printing is specific to 3DPC. The emphasis of this study lies in the layer-to-layer interfaces of 3DPC. The first aim of this study is to quantify the characteristics of the layer-to-layer interface and therefore characterize different aspects of the interfaces. The second aim of this study is to explore how the internal structure of printed concrete influences the mechanical performance of 3DPC. This research set out to design a series of experimental comparisons between 3DPC and casted concrete with the same compositions. Mechanical tests, i.e., compressive stress, ultrasonic Pulse Velocity test, flexural tension, and tension splitting, as well as the Ultrasonic Pulse Velocity test, were performed to check the mechanical performance of 3DPC. Contrary to what has often been expected, the mechanical test results showed the printed concrete has a quality not worse than casted concrete with the same recipe. Meanwhile, the X-ray computed tomography (X-CT) is used to characterize the internal structure, pore shapes, and interfaces of 3DPC. First, the investigation revealed that the lower total porosity and fewer big voids could be the fundamental causes meaning 3DPC has a better mechanical performance than casted concrete. Second, the statistics based on aspect ratio show that the distribution curves follow similar trends, regardless of the printed or casted concrete. Third, this study quantified the depth of the different interfaces for 3DPC. The results suggest that the porosity in an interface varies in a range. The author's pioneer work has contributed to our present understanding of the interfaces of 3DPC.

Unbonded interlayer evaluation in freshly 3D printed concrete using electrical resistivity measurements

Investigation of the Internal Structure of Hardened 3D-Printed Concrete by X-CT Scanning and Its Influence on the Mechanical Performance.

Bond shear performances and constitutive model of interfaces between vertical and horizontal filaments of 3D printed concrete

Interfacial bonding performance of 3D-printed Ultra-High Performance Strain-Hardening Cementitious Composites (UHP-SHCC) and cast normal concrete

Interfacial bonding properties of 3D printed permanent formwork with the post-casted concrete

Interfacial Properties of Three-Dimensional-Printed Permanent Formwork with Cast-in-Place Concrete

Hardened properties of 3D printed concrete: The influence of process parameters on interlayer adhesion

Triaxial compressive behavior of 3D printed PE fiber-reinforced ultra-high performance concrete

Bonding performance of 3D printing concrete with self-locking interfaces exposed to compression–shear and compression–splitting stresses

Interlayer Bond Strength Testing in 3D-Printed Mineral Materials for Construction Applications

Interlayer reinforcement of 3D printed concrete by the in-process deposition of U-nails

3D printing concrete with recycled coarse aggregates: The influence of pore structure on interlayer adhesion

Bond Performance Between BFRP Bars and 3D Printed Concrete

PVA Fibre Reinforced High-Strength Cementitious Composite for 3D Printing: Mechanical Properties and Durability

Assessing the Load-Bearing Capacity of 3D-Printed Concrete at Early Ages: An Innovative Approach

Failure analysis of 3D concrete printing bolted laminates mimicking geological strata

Trans-layer and inter-layer fracture behavior of extrusion-based 3D printed concrete under three-point bending

Interfacial constitutive model of 3D printed fiber reinforced concrete composites and its experimental validation

Influence of pore defects on the hardened properties of 3D printed concrete with coarse aggregate

Anisotropic mechanical properties of extrusion-based 3D printed layered concrete

Bonding properties between 3D printed coarse aggregate concrete and rebar based on interface structural characteristics