Abstract:Next-generation (5G/6G) wireless systems demand low-power mm-wave phased-array ICs. Variable-gain LNAs (VGLNAs) are key building blocks enabling hardware complexity reduction, performance enhancement and functionality extension. This paper reports a performance benchmarking of two low-power 30GHz VG-LNAs for phased-array ICs, which provide a 7.5dB gain control for 18dB Taylor taper in a 30GHz 8x8 antenna array, for a comprehensive validation of the new class of VGLNAs and its design methodology. In particular, this paper reports a second and implementation (VG-LNA2) with a reduced number (four) of gain-control back-gate voltages and super-low-Vt MOSFETs, with respect to the previous first implementation (VG-LNA1) with six gain-control back-gate voltages and regular- Vt MOSFETs, both in the same 22nm FDSOI CMOS technology. The results show that VG-LNA2 exhibits performance comparable to those of VG-LNA1, with a slightly lower power consumption. Overall, the performance benchmarking shows that the design methodology adopted for the new class of VG-LNAs leads to record low-power consumption and small form factor solutions reaching the targeted performances, regardless of the arrangements of the back-gate voltages for gain control and transistor sets, resulting in a comprehensive validation of the innovative design features and effective design methodology.

What problem does this paper attempt to address?

The problem that this paper attempts to solve is to design a low - power millimeter - wave phased - array integrated circuit (IC) for the next - generation (5G/6G) wireless communication systems, especially for variable - gain low - noise amplifiers (VG - LNAs). Specifically, the objective of the paper is to verify and benchmark the designs of two new types of low - power 30 - GHz VG - LNAs to ensure that they can meet the following requirements: 1. **Achieve a 7.5 - dB gain control**: Used to achieve an 18 - dB Taylor taper in a 30 - GHz 8x8 antenna array, thereby optimizing the performance of the antenna array. 2. **Low power consumption**: Ensure that the power consumption of each VG - LNA is less than 1 milliwatt (mW) to support the application of low - power phased - array receivers. 3. **Compact design**: Occupy a very small chip area, making large - scale integration possible. 4. **Verify the effectiveness of the design method**: Verify the feasibility and superiority of the new design method by comparing two different implementation methods (using different types of MOSFETs and different back - gate voltage configurations). To achieve these goals, the paper details the design and implementation of the two VG - LNAs and conducts a comprehensive benchmark and verification of their performance. Specifically, the paper compares the designs of two VG - LNAs: - **VG - LNA1**: Use regular - Vt MOSFETs and six back - gate voltages for gain control. - **VG - LNA2**: Use super - low - Vt MOSFETs and four back - gate voltages for gain control. By comparing the performance of these two designs, the paper shows that the new design method can not only significantly reduce power consumption while maintaining high performance but also reduce the chip area, thus providing key technical support for future 5G/6G phased - array receivers. ### Key Formulas and Parameters - **Gain control range**: 7.5 dB - **Taylor taper**: 18 dB - **Operating frequency**: 30 GHz - **Peak gain**: Approximately 16 dB (high - gain state) - **Noise figure (NF)**: Approximately 6 dB - **Power consumption (PC)**: - VG - LNA1: 0.97 mW (high - gain state), 0.41 mW (low - gain state) - VG - LNA2: 0.91 mW (high - gain state), 0.40 mW (low - gain state) These results indicate that the new VG - LNA designs have achieved the expected goals in terms of power consumption, performance, and area, especially performing well in low - power applications.

Benchmarking and Validation of Sub-mW 30GHz VG-LNAs in 22nm FDSOI CMOS for 5G/6G Phased-Array Receivers

Sub-mW 30GHz Variable-Gain LNA in 22nm FDSOI CMOS for Low-Power Tapered mm-Wave 5G/6G Phased-Array Receivers

A 6.512-GHz Balanced Variable-Gain Low-Noise Amplifier With Frequency-Selective Gain Equalization Technique

A 6.5-12 GHz Balanced Variable Gain Low-Noise Amplifier with Frequency-Selective Non-Foster Gain Equalization Technique

A 11.2 Mw 48–62 GHz Low Noise Amplifier in 65 Nm CMOS Technology

A Sub-GHz Low-Power Receiver Employing Resistive-Feedback-Tuned LNA with 2.1-Db NF and 106-Db Gain Tuning Range

A 28 GHz LNA using defected ground structure for 5G application

A 0.061-Mm² 1–11-Ghz Noise-Canceling Low-Noise Amplifier Employing Active Feedforward with Simultaneous Current and Noise Reduction

A Compact 2.1–39 GHz Self-Biased Low-Noise Amplifier in 65 Nm CMOS Technology

A Gm-boosted and current peaking wideband merged LNA and mixer

Technologies, Design, and Applications of Low-Noise Amplifiers at Millimetre-Wave: State-of-the-Art and Perspectives

A Broadband Variable-Gain Low-Noise Amplifier With Low NF and Dual Phase Compensation

Wideband Inductorless Low-Power LNAs with Gm Enhancement and Noise-Cancellation.

An MMIC LNA for Millimeter-Wave Radar and 5G Applications with GaN-on-SiC Technology

A Low-power, High-gain and Excellent Noise Figure GaN-on-SiC LNA Monolithic Microwave Integrated Circuit (MMIC) operating at Ka-band for 5G/6G Application

Design and Analysis of 9-mW 25.5–30.7-GHz CMOS Variable-Gain Amplifier Using Body-Floating Gain-and-Noise-Enhancement Technique

28 GHz Compact LNAs with 1.9 Db NF Using Folded Three-Coil Transformer and Dual-Feedforward Techniques in 65nm CMOS

A mm‐wave LNA employing current re‐use and non‐linearity cancellation in 28 nm CMOS for automotive RADAR and 6G receivers

A 60dB gain and 4dB noise figure CMOS V-band receiver based on two-dimensional passive Gm-enhancement

Millimeter-Wave Low-Noise Amplifier Design in 28-nm Low-Power Digital CMOS

28 GHz Compact LNAs with 1.9 Db Minimum NF Using Folded Three-Coil Transformer and Dual-Feedforward Techniques for Phased Array Systems