Abstract:We have developed novel impedance standards based on thin-film surface-mount-device (SMD) resistors. Due to the small dimensions of such resistors, the quantities determining their frequency dependence are very small and can be either measured or numerically calculated. A series connection of thin-film SMD resistors allows us to further improve the DC and the AC properties. The nominal resistance value of our application is 12.906 kohm but other values are just as possible. At frequencies up to 2 MHz, the calculated frequency dependence amounts to only a few parts per million of the DC value, which is about four orders of magnitude smaller than for all conventional calculable AC-DC resistors having a similar nominal DC value. To measure the frequency dependence, we use a precision inductance-capacitance-resistance (LCR) meter at frequencies up to 2 MHz that has a reproducibility of a few parts per million but a systematic uncertainty which is specified by the manufacturer to increase from 300 parts per million in the lower frequency range to 3000 parts per million at 2 MHz. Measurements of two very different SMD-based resistance standards allow verification of the model calculation as well as the calibration of the precision LCR meter, both with a relative uncertainty of a few parts per million in the whole frequency range. This boost in precision enables new applications in this frequency range such as the verification of conventional calculable resistance standards, the calibration of impedance standards, and future measurements of the quantum Hall resistance.

Measurement of Resistance Standards by a Precision LCR Meter at Frequencies up to 2 MHz

Resistance standards with calculable, nearly negligible AC-DC difference at frequencies up to 2 MHz for the calibration of precision LCR meters

High-frequency Characteristic of Four-Terminal-pair Standard Resistance

A Bridged Contactless Measurement Technique for LC Tank Based Voltage-Controlled Oscillator.

1 Ω-10 kΩ high precision transportable setup to calibrate multifunction electrical instruments

A Method to Determine LRRM Calibration Standards in Measurement Configurations Affected by Leakage

Equivalent Circuit Model Of Four-Terminal-Pair Capacitor Based On High-Frequency Traceable Measurement

Development and implementation of an automated four-terminal-pair Josephson impedance bridge

An LC Resonant Method for the Accurate Extraction of Small Parasitic Resistance

Shielding Method for A Resistance Comparison Bridge of Wide Frequency Range

Fundamentals of Measurement: Small Electric Currents

A sensitive electrometer based on a Rydberg atom in a Schrödinger-cat state

2-Terminal Coaxial Capacitance Measurements and Cable Corrections

Design of high accuracy resistance measuring instrument system

Calibration Method of a Wideband AC Resistance Voltage Divider Based on an Equivalent Model

Continuous measurement of complex modulus from 10–30 kHz

A Contactless Method for Measuring Amplitude and Phase of RF Voltages up to 26.5 GHz

Calibration Theory and Measurement Method of the Frequency Characteristics of the Four-Pair-Terminal Standard Capacitor

A potentially significant on-wafer high-frequency measurement calibration error

High precision measurement of the load effect of the resistor