Abstract:In this article, a wideband dual-component electric probe is designed for the simultaneous measurement of near-field tangential and normal electric fields. The probe has three sections, including a sensing section, a transmitting section, and an output section. The sensing section consists of two symmetric L-shaped monopoles, which can induce the electric field components in two directions. The responses are outputted to the receiving device through the substrate integrated coaxial line (SICL) in the transmitting section and the grounded coplanar waveguide (GCPW) in the output section. Through post-processing, the differential mode voltage and the common mode voltage of the two output voltages represent the induced intensity of the tangential electric component and the normal electric component, respectively. To reduce the interference of irrelevant field components and improve the calibration accuracy, the slot line is used to generate the standard tangential electric field, and the microstrip line is used to generate the standard normal electric field. Simulation and measurement results indicate that the proposed probe has a bandwidth of 4 to 16 GHz. The spatial resolution is 0.6 mm for measuring tangential electric field and 0.7 mm for normal electric field at 16 GHz. The near-field scanning results of the electric field distribution above the slot line and microstrip line demonstrate that the proposed probe can simultaneously measure two kinds of electric components efficiently.

A Contactless Method for Measuring Amplitude and Phase of RF Voltages up to 26.5 GHz

A Bridged Contactless Measurement Technique for LC Tank Based Voltage-Controlled Oscillator.

Contactless RF Probe Interconnect Technology Enabling Broadband Testing to the Terahertz Range

A New Scheme of Embedded RF Probe an Embedded Three-Port Loop of RF Parameters Detection

A Miniature Multi-Component Probe for Near-Field Scanning

Noncontact Measurement of Complex Permittivity of Electrically Small Samples at Microwave Frequencies

A Wideband and High Sensitivity Probe Design for Near-Field Scanning

A Miniature Resonant Magnetic Field Probe Integrated with MLCC

Noncontact measurement of complex permittivity based on the principle of mid-range wireless power transfer

A Wideband Tangential Electric Probe Based on Common Mode Absorbing

High-precision RF voltage measurements using longitudinal phase-space tomography in CERN PSB and SPS

A Resonant Magnetic Field Probe with Enhanced Sensitivity Using Quarter-wavelength Impedance Transformer

An Efficient Probe Calibration Based Near-Field to Near-Field Transformation for EMI Diagnosis

Contactless Measurement Of Electrical Conductivity Of Si Wafers Independent Of Wafer Thickness

Shielded cantilever with on-chip interferometer circuit for THz scanning probe impedance microscopy

Method for Accurately Measuring the Power-Frequency Parameters of Ehv/Uhv Transmission Lines

Chipless RFID Sensor for Measuring Time-Varying Electric Fields Using a Contactless Air-Filled Substrate-Integrated Waveguide Resonator

Analysis of broadband microwave conductivity and permittivity measurements of semiconducting materials

An Enhanced-Sensitivity Tangential Electric Field Probe With Tunable Resonant Frequency

Enhanced Electromagnetic Near Field Probe for Diagnosis and Materials Characterization

A Wideband Dual-Component Electric Probe for Near-Field Measurement