Abstract:Eddy current testing (ECT) is one of the most important techniques in nondestructive evaluation. A higher probe sensitivity is always pursued in ECT. To improve the probe sensitivity, the near electrical resonance signal enhancement (NERSE) technique was recently proposed. In the NERSE technique, a coaxial cable connecting with the probe coil is introduced to provide a capacitance for the electrical resonance. However, the long coaxial cable is awkward and inconvenient in engineering applications, restraining the usability of such probes. Metamaterials (MTMs) are novel artificial electromagnetic media and have been proved to be effective in manipulating the impedance of a solenoid coil. In other words, in principle, MTMs can be used in the same way as that a coaxial cable in NERSE in ECT. Based on this argument, low-frequency magnetic MTMs are introduced as the probe cores to provide a new approach to achieve the electrical resonance for the NERSE technique. A promising feature of the proposed approach is that the detecting signals and sensitivity are significantly increased due to the extraordinary electromagnetic properties of the MTM. The most salient features of an MTM core over a ferrite core are: 1) effective permeability of the MTM core will vary sharply from a high positive to a high negative values when crossing the resonance frequency, resulting in not only a high magnetic flux density in the tested material but also an extremely large variation of the normalized impedance which is very essential in identifying a crack and 2) electromagnetic properties of an MTM will increase with the increase of frequency, whereas those of a ferrite material usually degrade sharply with the increase of frequency. To demonstrate the advantages of the proposed new probe, comprehensive numerical and experimental studies are conducted, and the results have shown the high performance of the proposed probe. In addition, the proposed MTM-core probe also exhibits a diverse versatility and convenience in engineering applications as compared with the existing NERSE technique.

Enhanced Electromagnetic Near Field Probe for Diagnosis and Materials Characterization

A Miniature Multi-Component Probe for Near-Field Scanning

An Efficient Probe Calibration Based Near-Field to Near-Field Transformation for EMI Diagnosis

A Simple High-resolution Near-field Probe for Microwave Non-Destructive Test and Imaging

A Wideband and High Sensitivity Probe Design for Near-Field Scanning

Metamaterial-Core Probes for Nondestructive Eddy Current Testing.

A Resonant Magnetic Field Probe with Enhanced Sensitivity Using Quarter-wavelength Impedance Transformer

A Miniature Resonant Magnetic Field Probe Integrated with MLCC

T0301-2-5 Modifying the Structure of Microwave AFM Probe for Improving the Sensitivity in the Measurement of Electrical Properties

Enhancement of Sensitivity for the Evaluation of Electrical Properties by Modifying the Nano Structure of Microwave Afm Probe

An Enhanced-Sensitivity Tangential Electric Field Probe With Tunable Resonant Frequency

T0401-2-1 Development of a Microwave AFM Probe for the Evaluation of Electrical Properties

A Wideband EzEx Field Probe Integrated with a Strip Line Magic-T

Miniature Active Differential Magnetic Field Probe with High Sensitivity for Near-Field Measurements

A High Frequency Probe with End Launch Structure

Design of Microstrip Line used for Probe Calibration up to 40 GHz

Probe Design and Source Reconstruction for Near-Field Scanning and Modeling

A Wideband Tangential Electric Probe Based on Common Mode Absorbing

A High-Sensitivity Resonant Tangential E-Probe With Loaded Improved Dipole and Embedded Integrated Balun

Investigation of Multilayer Print Circuit Board Probe with Temperature Compensation for Ultra-Wideband Near-Field Measurement

A High-Frequency and High Spatial Resolution Probe Design for EMI Prediction