Abstract:In recent years, oxy-fuel combustion in coal-fired plants has become one of the most promising technologies for carbon capture and storage (CCS). Compared with air-fired combustion, high concentrations of CO2 and H2O in the flue gas cause a remarkable change in the pulverized coal combustion and heat transfer characteristics in furnace. In this study, improved models for the gas radiative properties and chemical reaction mechanisms were incorporated into the computational fluid dynamics (CFD) code to simulate a 200 MWe tangentially fired utility boiler, which is expected to operate at full load under both conventional air-fired and oxy-fuel combustion. Different flue gas recycle patterns: dry recycle and wet recycle, were also investigated. The results indicate that, stable combustion is achieved by a compatible burner design in both air-fired and oxy-fuel combustion. In the oxy-fuel combustion, the flue gas peak temperature and wall heat flux decrease and high CO concentration appears in the burner region, resulted from higher heat capacity of CO2 and chemical effect of CO2 (Liu et al., 2003, Glarborg and Bentzen, 2008). Based on the comparison of the wet recycle and dry recycle, it shows the wet recycle has more advantages than dry recycle. This study indicates a slight increase in total heat transfer, when the oxygen concentration in oxidant increases from 23% to 29%, consistent with the results of Vattenfall and Callide pilot scale oxy-combustion plant. Thus, compared with air-fired combustion, the full load of a boiler may decrease by 5-10% under oxy-fuel combustion. (C) 2014 Elsevier Ltd. All rights reserved.

Cause analysis and solutions about slagging of 670 t/h boiler in Zhuozi Power Plant

Experimental Investigation of the Scaling-Off Location and the Slag Mass in Pulverized Coal-Fired Boiler with Water-Cooled Slag Removal

Solution to the Problems of Fire-Carrying in Primary Air Jet Orifice in 125MW Units

Numerical Investigation on Oxy-Combustion Characteristics of a 200 MWe Tangentially Fired Boiler

Investigation on slagging and high-temperature corrosion prevention and control of a 1000 MW ultra supercritical double tangentially fired boiler

Experimental research on the fire-carrying problems in primary air nozzle of 125 MW units

CAUSE ANALYSIS AND TEST STUDY ON SOMEHAT LOWER STEAM TEMPERATURE FOR A 2008t/h CORNER TANGENTIAL FIRING BOILER

Theoretical and In-situ Experimental Investigation on Reducing Slagging Damage for Swirl-opposed Fired PC Boiler with Non-designed Blending Coals

Test Study Upon Slagging on the Heating Surface of Pulverized Coal Boiler

Investigation on Slagging Using Biased Secondary Air for Tangential Boiler

Influence of improving medium-speed pulverizer outlet temperature on the operation of boiler

The integrated analysis of economy and safety on SOFA running mode of a 600MWe boiler

Analysis on reasons of jam fault of hot primary air valve in 600 MW coal-fired boiler and countermeasures

SLAGGING ANALYSIS AND PREVENTION OF UTILITY BOILERS WITH TILTING BURNERS

Experimental Study on Slagging Monitoring of Pulverized Coal-Fired Boiler Based on Slagging Image

Harmfulness and Preventing Measures of Slagging in Heated Surfaces of Boiler

Analysing the Cause of High Temperature Corrosion in the Superheaters of Power Plant Systems

CONCENTRATED PRIMARY AIR ARRANGEMENT TO MAKE BITUMINITE BURNED BOILER SLAGGING - PREVENT AND LOW NOx RELEASE

Application of Air-staged and Low NOx Emission Combustion Technology in Plant Boiler

Optimal Control of Gas Temperature Deviation in a 660 MW Supercritical Tangentially-fired Boiler

Experimental and Numerical investigations in a gas-fired boiler with combustion stabilizing device