Abstract:For an accelerator magnet, a certain mechanical strength is required to sustain against a transverse compression stress due to Lorentz force. A bronze-route Nb3Sn wire with Cu-Nb reinforcement was developed by Tohoku University and Furukawa Electric to enhance the strength against axial tension. The Cu-Nb reinforcement wire also exhibited some indication of strength improvement against transverse compression; however, the details of a reinforcement mechanism for the transverse compression stress have not been clarified. In this study, the internal strains of Nb3Sn bronze-route wires with and without the Cu-Nb reinforcement under transverse compression stress were evaluated by neutron diffraction at BL19 (TAKUMI) in J-PARC. The samples were attached to jig with solder only at the ends and compression was applied at the center of the samples with 30-mm anvil with 5-mm wide and 8- to 15-mm high beam. Since a critical current, Ic of a superconducting wire depends on the three-dimensional strain, internal strain of Nb3Sn along the axial and two orthogonal radial directions were evaluated at room temperature (RT). In the different setup, Ic measurements of the wires under transverse compression stresses were also performed at 4.2 K and 14.5 T. Using 3-mm wide anvil, the transverse compression was applied at 4.2 K or RT. The neutron diffraction results indicated no significant differences in the internal strains of Nb3Sn under transverse compression between the samples with and without Cu-Nb reinforcement, while the Ic measurements showed potential increase in the irreversible stress (irr) for Cu-Nb reinforced wires. The reason for this discrepancy was discussed based on the difference in the experimental setups for each measurement.

Deformation Behavior and Degradation on Rutherford Cabling of Nb 3 Sn Wires

Nb3Sn wire shape and cross sectional area inhomogeneity in Rutherford cables

Determination of the electromechanical limits of high-performance Nb$_3$Sn Rutherford cables under transverse stress from a single-wire experiment

Study on the Nb3Sn Rutherford Cable for High-Energy Accelerators

Metallographic Investigation of First Full-Size High-Jc Nb3Sn Cable-in-conduit Conductor after Cyclic Loading Tests

Internal Strain Measurement by Neutron Diffraction Under Transverse Compressive Stress for Nb 3 Sn Wires With and Without Cu-Nb Reinforcement

Numerical Simulation of the Cable Breakage Based on Electromagnetic NDE Method for Nb3Sn Cable-In-Conduit Conductors

Experimental verification of the temperature and strain dependence of the critical properties in Nb/sub 3/Sn wires

Performance Degradation of Multi-Layer Spiral Cable During Manufacturing Procedure

AC Loss and Contact Resistance In Copper-Stabilized Nb3Al Rutherford Cables with and without a Stainless Steel Core

Numerical Simulation of the Mechanical Properties of the $\hbox{nb}_{3}\hbox{sn}$ CICCs under Transverse Cyclic Loads

Minimum Quench Energy Of Nb$_3$Sn Wires With High Specific Heat Tape

Local Plastic Deformation Effects on the Critical Current of High-Jc Nb3Sn Strands under Uniaxial Strain

Stress–Strain Distribution Analysis in Bi2212 Subcable Based on Numerical Modeling and Experiment

Local plastic deformation effects on the critical current of high-J c Nb 3 Sn strands under uniaxial strain

Indentation Effects on Strain Sensitivity of Critical Current for Internal-Tin Nb3Sn Strand

CORD, A Novel Numerical Mechanical Model for ${\rm Nb}_{3}{\rm Sn}$ CICCs

A Combined Testing and Modelling Methodology for the Mechanics of High-Field Superconducting Magnets

Rutherford MgB2 cable with resistive NbTi barriers and CuNi30 sheath.

Bending Tolerance of React&Wind Nb 3 Sn Conductors for Fusion Magnets

Almost Kahler 4-manifolds with J-invariant Ricci tensor and special Weyl tensor