Abstract:This paper deals with a systematic investigation on the synthesis of aluminium oxide starting from mono hydroxy aluminium oxide (boehmite, (AlOOH)) which in turn is synthesized from aluminium nitrate. Boehmite on heating forms γ, transitional alumina and α-alumina phases in the temperature range 400–600, 800–1050 and 1050–1100°C respectively. Calculation from XRD, using Scherer equation shows that γ-alumina has crystallite size in the range 5–10 nm, while δ and θ-alumina are in the range 10–20 nm and α-alumina is about ∼33 nm. The textural features of aqueous sol-gel boehmite samples calcined at various temperatures were analyzed by specific surface area measurements and adsorption isotherm features. Maximum specific surface area of 266 m2/g is observed for the precursor calcined at 400°C and a minimum of 5 m2/g at 1100°C. Total pore volume is maximum for the precursor calcined at 600°C (0.2653 cm3/g). Average pore size ranges from ∼3 nm (400°C) to ∼11 nm (1100°C). The adsorption isotherms also show a change from Type IV to Type II with increase in temperature showing difference in surface properties. The information from t-plots, pore size distribution and cumulative pore volume data also indicates differences in porosity features of boehmite on calcination. The adsorption isotherm and pore size distribution analysis show maximum microporosity at 400°C, while maximum mesoporosity is observed at 600°C. At higher temperatures, porosity decreases, even though small fraction of pores in the mesopore range is still retained. At 1100°C, there is structural transformation from transitional to α-alumina, with very low specific surface area ∼5 m2/g and pores in the size range of 11 nm. The various data presented in this study will be useful in the synthesis of alumina with tailor made properties.

Relationship between formation conditions, properties, and crystallite size of boehmite

Different nanostructures of boehmite fabricated by hydrothermal process: effects of pH and anions

Size and Morphology Controlled Synthesis of Boehmite Nanoplates and Crystal Growth Mechanisms

Adsorption Isotherm and Pore Characteristics of Nano Alumina Derived from Sol-Gel Boehmite

Reactive Crystallization Kinetics Study of Boehmite in Ammonia Solution by Adding Ammonium Aluminum Sulfate

Effects of synthetic conditions on the textural structure of pseudo-boehmite

Preparation and characterisation of boehmite precursor and sinterable alumina powder from aqueous aluminium chloride-urea reaction

Hydrothermal Preparation Of Boehmite Nanorods By Selective Adsorption Of Sulfate

Effect of NaOH Concentration on Formation of Ba4Ti13O30 and BaTi5O11 Nanocrystals Prepared by Hydrothermal Method

Morphological Controlled Growth of Nanosized Boehmite with Enhanced Aspect Ratios in an Organic Additive-Free Cationic–Anionic Double Hydrolysis Method

Facile Synthesis of Hierarchical Flower-Like Γ-Alooh Films Via Hydrothermal Route on Quartz Surface

Study on Preparation of Yttrium Oxide with Large Particle Sizes and Spherical Shapes by Precipitation with Ammonium Bicarbonate

Boehmite Preparation via Alditols-Interacting Transformation of Metastable Intermediates in Al–H2O Reaction Crystallization

Influence of the sediment properties of Al2O3· xH2O on the hydrothermal formation alooh whiskers

Spontaneous Formation of Nano‐fibrillar Boehmite and the Enhancement Effect of Polyethylene Glycol

Pore structure of aluminas derived from the alkyl derivatives of boehmite

Influence of the Sediment Properties of Al2O3⋅xH2Oon the Hydrothermal Formation AlOOH Whiskers

Synthesis of Nano-Alumina Hydroxide Sol Using Sol-gel Method

Preparation and Characterization of Transparent Boehmite (γ-AlOOH) Sol

Preparation of Pseudo-Boehmite and Gamma-Al2o3 by Polyaluminum Chloride Ii -Surfactant Influences

Optical and structural properties of spherical-shaped boehmite and γ-alumina nanoparticles by ultrasonic-assisted hydrothermal method: the effects of synthesis route, calcination, and precursor concentration