Abstract:Bounding surface plasticity has been widely used for capturing the stress–strain behaviour of geomaterials. However, it may require multiple sets of model parameters for constitutive modelling of sands with a wide range of initial states, because of the distinct critical state characteristics under low and high densities or pressures in the <span class="mathjax-tex">\(e-\ln {p}'\)</span> plane. In this study, an enhanced bounding surface plasticity approach for sand with a wide range of initial material states is developed. A fractional plastic flow rule and a modified critical state line are suggested, which ensures that without using any predefined state indices, the developed model can consider the state-dependent dilatancy and hardening behaviours of sand subjected to low and high pressures/densities. The approach is validated by simulating the well-documented test results of Toyoura sand and Sacramento River sand. For comparison, the original state-dependent dilatancy approach in Li and Dafalias (Géotechnique 50(4):449–460, 2000. <a href="https://doi.org/10.1680/geot.2000.50.4.449">https://doi.org/10.1680/geot.2000.50.4.449</a>) is also adopted and implemented. It is found that the two approaches can reasonably capture the typical stress–strain behaviour, e.g. hardening/contraction, softening/dilation, liquefaction, quasi-steady state flow, and non-flow, of sands with different initial material states, by using a single set of model parameters. However, compared to the current work, Li and Dafalias (2000) model relied on a predefined state parameter, for capturing the state-dependent behaviour of sand under a wide range of initial states

Modified SANISAND‐F model for simple shear path

Hypoplastic Model for Sand under Multidirectional Shearing Conditions Considering Fabric Change Effect

Hypoplastic Modeling of Anisotropic Sand Behavior Accounting for Rotation of Principal Stress Direction

Failure Mechanisms of Sand under Asymmetrical Cyclic Loading Conditions: Experimental Observation and Constitutive Modelling

Non-coaxial hypoplastic model for sand with evolving fabric anisotropy including non-proportional loading

Flow Deformation and Cyclic Resistance of Saturated Loose Sand Considering Initial Static Shear Effect

Multishear Bounding Surface Modelling of Anisotropic Sands Accounting for Fabric and Its Evolution

SANISAND‐FN: An evolving fabric‐based sand model accounting for stress principal axes rotation

SANISAND-H: A sand bounding surface model for high pressures

Micromechanics-based multimechanism bounding surface model for sands

SANISAND-MS-T: Simple ANIsotropic SAND model with Memory Surface for Temperature effects

Formula for inclination angle of shear band based on soil state and microscopic characteristics in sands

A unified monotonic model for sand based on modified hyperbolic equation and state-dependent dilatancy

Three‐dimensional Anisotropic Plasticity Model for Sand Subjected to Principal Stress Value Change and Axes Rotation

SANISAND‐C*: Simple ANIsotropic constitutive model for SAND with Cementation

Small-strain Shear Moduli Modeling of Sand: a Non-Equilibrium Thermodynamic Approach, Including an Application to Leighton Buzzard Sand

Constitutive modeling of principal stress rotation associated with sand under simple shear loading

A hypoplastic model for sand-fines mixtures

Calibration and validation of a sand model considering the effects of wave-induced principal stress axes rotation

Bounding surface plasticity for sand using fractional flow rule and modified critical state line

A Basic Constitutive Model for Sands