Abstract:The pre-peak microstructure evolution of the material is crucial in determining the strength and failure scheme of the material, but is not captured by the existing shear strength parameters models which focus on post-peak stage information. Novel concepts of pseudo-cohesion and pseudo-internal friction angle that account for both the pre-peak and post-peak stage information were proposed in this study, based on the experimentally observed response of the rock mechanics parameters to an external load (the maximum principal stress). These two parameters were analytically derived as functions of maximum principal strain, with coefficients to be determined (i.e., by applying the Mohr–Coulomb criterion with these parameters to experimental data). The dependence of pseudo-cohesion and pseudo-internal friction angle on the axial strain and confining pressure was investigated. The evolution of the strength parameters was found to relate to the propagation of micro-crack developed in the loading process, as revealed by PFC 2D simulations reproducing experiments. The results show that (1) analytical model characterizing the pseudo-cohesion and internal friction angle as the quadratic function of axial strain accurately reflects the mechanical response characteristics of the specimen; (2) before the residual stage, the pseudo-cohesion first increases and then decreases with increasing strain, while the pseudo-internal friction angle increases continuously; (3) for the sandstone specimens studied, the pseudo-cohesion at the peak stress increases by a gradually decreasing rate with increasing confining pressure, while the pseudo-internal friction angle at the peak stress decreases by a decreasing rate with the increasing confining pressure; (4) CPM well characterized the mechanical properties of rock under multiple confining pressures, as the total stress–strain curves and failure modes of numerical specimens reproduced the experimental results. The evolution of rock pseudo-shear strength parameters is closely related to the external load and the generation, propagation, and penetration process of rock cracks. The rock pseudo-shear strength parameters are gradually mobilized with the increasing load, and the propagating of cracks owing to the decrease of mobilizable maximum cohesion and the increase of mobilizable maximum internal friction angle.

Formula for inclination angle of shear band based on soil state and microscopic characteristics in sands

Discrete Element Modeling of Sand Behavior in a Biaxial Shear Test

Experimental Study on the Features of Infrasonic Waves of Sandstone under Shear Load

Research on direct shear test of rock-like materials with two closed pre-existing cracks of different attitudes

A New Index for Evaluating Liquefaction Resistance of Soil under Combined Cyclic Shear Stresses

Experiment of initial relative density effects on sand strength

Shear Wave Velocity in Sand Considering the Effects of Frequency Based on Particle Contact Theory

Measurement of Small Strain Shear Modulus of Clean and Natural Sands in Saturated Condition Using Bender Element Test

Development of a shear strength model for a rock mass containing a complex fracture system based on direct shear tests: a case study

Dip effect on the orientation of rock failure plane under combined compression–shear loading

Study on reverse fault rupture propagation through sand with inclined ground surface

A New Parameter to Evaluate Liquefaction Resistance of Saturated Sand under Complex Dynamic Stress Paths

Modified SANISAND‐F model for simple shear path

Experimental Study on Asymptotic Behaviour of Anisotropic Sand

A novel obtaining method and mesoscopic mechanism of pseudo-shear strength parameter evolution of sandstone

Failure and mechanical behavior of transversely isotropic rock under compression-shear tests: Laboratory testing and numerical simulation

Study of shear properties and shear model of soil-rock mixture

Bifurcation analysis of shear band in sand under true triaxial conditions with hypoplasticity

Shear Failure Mechanisms of Sandstone Subjected to Direct, True Triaxial and Confining Shear Test Conditions

Small-strain Shear Moduli Modeling of Sand: a Non-Equilibrium Thermodynamic Approach, Including an Application to Leighton Buzzard Sand

Experimental Study on Mesoscopic Shear Behavior of Calcareous Sand Material with Digital Imaging Approach