Abstract:Shear modulus is an essential parameter for deformation prediction and site response analysis of geological problems. This paper considers the dynamic shear modulus degradation of saturated marine coral sand containing fine particles from a reef in the Nansha Islands. Resonant-column tests were carried out on specimens of the saturated coral sand with varying non-plastic fines content (FC) and relative density (Dr) subjected to initial effective confining pressure (sigma ' m). The test results show that the stress exponent n-which reflects the rate of increase of the maximum dynamic shear modulus (Gmax) with increasing sigma ' m-is a soil-specific constant. A significant finding is that the equivalent skeleton void ratio e*sk has a unique power relationship with the normalised maximum dynamic shear modulus [Gmax/(sigma ' m/Pa)n]. An improved Hardin model based on binary packing theory is proposed to evaluate Gmax of the coral sand, and its applicability is verified using experimental data for three different sands from the literature. For a given shear strain, dynamic shear modulus G decreases with increasing FC and increases with increasing Dr and sigma ' m. The curves of the maximum dynamic shear modulus rate (G/Gmax) tend to fall with increasing FC, while Dr and sigma ' m have little influence on G/Gmax. The fitting parameters A and B of the Davidenkov model are insensitive to sigma ' m, Dr, and FC and are fixed at 1.08 and 0.42, respectively, for the saturated coral sand. Furthermore, the reference shear strain gamma 0 in the Davidenkov model-corresponding to the shear strain at G/Gmax = 0.5-can be evaluated uniformly by e*sk regardless of sigma ' m, Dr, and FC. A unified form of shear-strain-dependent G prediction method is established and provides a significant advantage in evaluating G for marine coral sand in practice.

Measurement of Small Strain Shear Modulus of Clean and Natural Sands in Saturated Condition Using Bender Element Test

Discrete Element Modeling of Sand Behavior in a Biaxial Shear Test

Previbration Signature on Dynamic Properties of Dry Sand

Discrete-Element Simulation of Dense Sand under Uni- and Bidirectional Cyclic Simple Shear Considering Initial Static Shear Effect

Effects of Initial Static Shear on Cyclic Resistance and Pore Pressure Generation of Saturated Sand

Shear Wave Velocity in Sand Considering the Effects of Frequency Based on Particle Contact Theory

A New Index for Evaluating Liquefaction Resistance of Soil under Combined Cyclic Shear Stresses

Experiment of initial relative density effects on sand strength

Shear modulus reduction of saturated sand under large liquefaction-induced deformation in cyclic torsional shear tests

Experimental Research On Behaviors Of Saturated Loose Sand Subjected To Oblique Ellipse Stress Path

Shear Modulus and Damping Ratio of Sand–Gravel Mixtures Over a Wide Strain Range

Experimental investigation on shear wave velocity of sand-silt mixtures based on the theory of inter-grain contact state

Experimental Study on Dynamic Characteristics of Saturated Soft Clay with Sand Interlayer under Unidirectional and Bidirectional Vibration

Formula for inclination angle of shear band based on soil state and microscopic characteristics in sands

A New Parameter to Evaluate Liquefaction Resistance of Saturated Sand under Complex Dynamic Stress Paths

Experimental Investigation of Dynamic Shear Modulus of Saturated Marine Coral Sand

Preliminary Tests of Measuring Shear Wave Velocity on Soil Surface Using Bender Elements

International Parallel Test on the Measurement of Shear Modulus of Sand Using Bender Elements

A New Method For Evaluating Small-Strain Shear Modulus Of Sandy Soils Based On Binary Medium Model

Small-strain shear modulus of calcareous sand under anisotropic consolidation

Effect of Multiscale Particle Morphology on Small-Strain Shear Modulus of Irregularly Shaped Sand under Isotropic Consolidation: Triaxial Bender Element Tests on 3D-Printed Sand