Abstract:Huge and critical structures, such as fuel storage tanks and nuclear power plants, are often built on dense sandy grounds, which may cause excessive plastic deformations under multidirectional cyclic shearing conditions caused by earthquakes. The lack of investigation of sand behavior under multidirectional loading may lead to unsafe designs, and thus significantly increase the maintenance cost for infrastructures during their long operational time, which might be longer than 100 years. This study presents a numerical investigation on the liquefaction behavior of dense sand under bidirectional cyclic simple shear using the discrete element method. The bidirectional cyclic simple shear tests with varying stress trajectories on the deviatoric stress plane, including figure-8, circular, and straight lines, were conducted. Additionally, a series of unidirectional loading tests was conducted in the simulation scheme for comparison purposes. The effect of the initial static shear on the cyclic behavior and liquefaction resistance of granular materials was examined. Four loading categories, including full reversal, partial reversal, intermediate reversal, and no reversal, were implemented in the numerical simulations. Although the presence of the initial static shear may enhance the cyclic resistance of granular samples under unidirectional loading, it mitigates the liquefaction resistance and promotes the failure of specimens under bidirectional shearing conditions. The microscopic analysis was performed to reveal the relationship between the fabric evolution and external loading, which can provide profound insights into the underlying mechanism of the cyclic behavior and liquefaction susceptibility of granular material when both the bidirectional shearing and initial static shear effects are considered.

Effect of Multiscale Particle Morphology on Small-Strain Shear Modulus of Irregularly Shaped Sand under Isotropic Consolidation: Triaxial Bender Element Tests on 3D-Printed Sand

Particle Shape Effects on the Shear Behaviors of Granular Assemblies: Irregularity and Elongation

A Multiscale Investigation of Strain Localization in Cohesionless Sand

Discrete Element Modeling of Sand Behavior in a Biaxial Shear Test

Discrete-Element Simulation of Dense Sand under Uni- and Bidirectional Cyclic Simple Shear Considering Initial Static Shear Effect

Micromechanical Investigation of the Shear Behaviors of Sand‒rubber Mixtures Using a Multibody Meshfree Method

Experiment of initial relative density effects on sand strength

Shear Modulus and Damping Ratio of Sand–Gravel Mixtures Over a Wide Strain Range

A comprehensive numerical investigation of multi-scale particle shape effects on small strain stiffness of sands

Influence of Cyclic Loading History on Small Strain Shear Modulus of Saturated Clays

Measurement of Small Strain Shear Modulus of Clean and Natural Sands in Saturated Condition Using Bender Element Test

Effect of particle size on small strain stiffness of biotreated sands

Small-strain shear modulus of calcareous sand under anisotropic consolidation

Small-strain shear modulus (Gmax) and microscopic pore structure of calcareous sand with different grain size distributions

Effect of Anisotropic Stress State on Elastic Shear Stiffness of Sand–Silt Mixture

EXPERIMENT AND DISCRETE ELEMENT NUMERICAL SIMULATION FOR INFLUENCE OF PARTICLE MORPHOLOGY ON SHEAR STRENGTH OF SAND

Factors Affecting Small-Strain Shear Modulus of Sand–Silt Mixture Considering Different Moisture Contents

Effect of Particle Shape on the Liquefaction Resistance of Calcareous Sands

Experimental Study on Asymptotic Behaviour of Anisotropic Sand

Anisotropic behaviors of calcareous sand dependent on loading direction and initial shear stress

Small-strain Shear Moduli Modeling of Sand: a Non-Equilibrium Thermodynamic Approach, Including an Application to Leighton Buzzard Sand