Abstract:Due to the behavior of low-density and high-energy absorption efficiency, rubber materials are now being extensively applied to solve geotechnical problems. In order to ensure the rational and economical use of rubber sand mixtures in geotechnical engineering, it is necessary to systematically study the compression behavior of rubber sand mixtures, especially under repeated loading–unloading mode. In this study, three series tests, including one-dimensional compression tests and repeated loading–unloading tests, were conducted on rubber sand mixtures with various rubber contents. The development of the void ratio, compression coefficient, elastic strain, and plastic strain of the mixtures under different load modes was investigated. Results showed that compared to pure sand, rubber sand mixtures exhibited different compression deformation behavior. The rubber content had a significant impact on the compression behavior of rubber sand mixtures. The compression behavior of the rubber sand mixture changed from low to high compressibility when the rubber content was greater than 10%. Also, with the increase of rubber content from 0% to 20%, the ratio between elastic and plastic strain of the mixtures increased from 1∶5 to 2∶3. When subjected to loading and unloading cycles within a large stress range (0–1,600 kPa), the rubber sand mixture underwent significant elastic strain, and plastic strain gradually accumulated with the number of cycles. When the repeated loading and unloading test started at a certain initial pressure (800–1,600 kPa), the elastic deformation of the rubber sand mixture decreased to a smaller level and did not change significantly with the number of cycles. At this point, plastic strain mainly occurred in the first cycle, and almost no plastic strain occurred in subsequent cycles. Rubber content below 10% has lower compressibility and is a recommended rubber content (RC) value for use in engineering. In addition, setting a certain initial pressure is an effective method to reduce the elastic strain of mixtures and improve the accumulation of plastic strain in engineering applications.

Micromechanical Investigation of the Shear Behaviors of Sand‒rubber Mixtures Using a Multibody Meshfree Method

Shear Behaviour of Sand-Rubber Mixtures: Interpretation from Energy Transformation and Force Chain Evolution

Discrete Element Modeling of Sand Behavior in a Biaxial Shear Test

The micro-mechanical behaviour of sand–rubber mixtures under shear: A numerical study based on X-ray micro-tomography

EFFECT OF PARTICLE SIZE RATIO AND MIX RATIO ON MECHANICAL BEHAVIOR OF RUBBER-SAND MIXTURES

Experimental Characterization and Finite Element Modeling the Deformation Behavior of Rubbers with Geometry Defects

A micromechanical investigation of sand–rubber mixtures using the discrete element method

Strength and deformation behaviour of sand-rubber mixture

Effect of rubber particles on mechanical properties of calcareous sand under large displacement shear

Effect of the particle size ratio on macro- and mesoscopic shear characteristics of the geogrid-reinforced rubber and sand mixture interface

Stress level dependent behavior of sand-rubber mixtures

Evaluation of dynamic shear modulus and damping ratio of rubber-sand mixture based on cyclic simple shear tests

Shear modulus of sand-rubber mixtures: element testing and constitutive modeling

Effect of Rubber-Sand Particle Size Ratio on Shear Properties of Rubber-Sand Mixtures under Normal Cyclic Loading

Effect of Rubber-Sand Mixtures Gradation on Shear Characteristics of Mixed Soil

Micromechanics-based multimechanism bounding surface model for sands

Effect of particle size and shape on shear strength of sand–rubber granule mixtures

Compression characteristics and particle scale stress distribution of sand-rubber mixtures with particle size disparity effect

Factors Affecting Strength and Stiffness of Dry Sand-Rubber Tire Shred Mixtures

Dynamic shear modulus and damping ratio of rubber-sand mixtures with a wide range of rubber content

Experimental Investigation on the Compressive Behavior of Rubber–Sand Mixtures under Repeated Loading–Unloading