Abstract:To study the shear characteristics of rubber-sand mixtures, the effects of four rubber-sand mixtures gradations（one type of gap gradation, two types of continuous gradations, and one type of open gradation）, three rubber contents（10%, 30%, and 60%）, and three vertical stresses（30 kPa, 60 kPa, and 90 kPa） on the strength characteristics and volumetric change characteristics of rubber-sand mixtures were investigated by using a laboratory large-scale direct shear apparatus; and based on the laboratory direct shear test, the discrete element numerical models of pure sand and rubber-sand mixtures were established according to the same gradation and rubber content. The intrinsic mechanical mechanism of rubber-sand mixtures was explored from the perspective of particle contact state and displacement. The results show that the shear stress curve of rubber-sand mixtures is the same as that of pure sand at low rubber content, but its shear strength is lower than that of pure sand; the shear stress of rubber-sand mixtures increases with the increase of vertical stress, and the shear strength of continuous gradation SR2 is the highest among the four gradations of rubber-sand mixtures; the admixture of rubber particles can effectively inhibit the dilatancy of sandy soil, among which the gap grade SR1 has the best effect on inhibiting soil dilatancy, and the dilatancyis reduced by 37% compared with that of pure sand. The internal friction angle of rubber-sand mixtures decreases with the increase of rubber content, and the internal friction angle of continuous gradation SR2 is the largest under the same rubber content; rubber particles mainly participate in the formation of weak force chain in the rubber-sand mixtures force chain network, and the shear zone width of rubber-sand mixtures is smaller than that of pure sand.

Shear modulus of sand-rubber mixtures: element testing and constitutive modeling

Micromechanical Investigation of the Shear Behaviors of Sand‒rubber Mixtures Using a Multibody Meshfree Method

Shear Behaviour of Sand-Rubber Mixtures: Interpretation from Energy Transformation and Force Chain Evolution

Strength and deformation behaviour of sand-rubber mixture

Experimental Study on Dynamic Modulus and Damping Ratio of Rubber-Sand Mixtures over a Wide Strain Range

Evaluation of dynamic shear modulus and damping ratio of rubber-sand mixture based on cyclic simple shear tests

Effect of layering and pre-loading on the dynamic properties of sand-rubber specimens in resonant column tests

Dynamic shear modulus and damping ratio of rubber-sand mixtures with a wide range of rubber content

Shear Modulus and Damping Ratio of Sand–Gravel Mixtures Over a Wide Strain Range

Stress level dependent behavior of sand-rubber mixtures

Factors Affecting Strength and Stiffness of Dry Sand-Rubber Tire Shred Mixtures

The micro-mechanical behaviour of sand–rubber mixtures under shear: A numerical study based on X-ray micro-tomography

Effect of Rubber-Sand Particle Size Ratio on Shear Properties of Rubber-Sand Mixtures under Normal Cyclic Loading

Effect of Rubber-Sand Mixtures Gradation on Shear Characteristics of Mixed Soil

A micromechanical investigation of sand–rubber mixtures using the discrete element method

Effect of particle size and shape on shear strength of sand–rubber granule mixtures

Cyclic and Dynamic Behavior of Sand–Rubber and Clay–Rubber Mixtures

Effect of Anisotropic Stress State on Elastic Shear Stiffness of Sand–Silt Mixture

Viscoelastic Constitutive Model of Rubber Mix

Measurement of Small Strain Shear Modulus of Clean and Natural Sands in Saturated Condition Using Bender Element Test

EFFECT OF PARTICLE SIZE RATIO AND MIX RATIO ON MECHANICAL BEHAVIOR OF RUBBER-SAND MIXTURES