Abstract:To study the shear characteristics of rubber-sand mixtures, the effects of four rubber-sand mixtures gradations（one type of gap gradation, two types of continuous gradations, and one type of open gradation）, three rubber contents（10%, 30%, and 60%）, and three vertical stresses（30 kPa, 60 kPa, and 90 kPa） on the strength characteristics and volumetric change characteristics of rubber-sand mixtures were investigated by using a laboratory large-scale direct shear apparatus; and based on the laboratory direct shear test, the discrete element numerical models of pure sand and rubber-sand mixtures were established according to the same gradation and rubber content. The intrinsic mechanical mechanism of rubber-sand mixtures was explored from the perspective of particle contact state and displacement. The results show that the shear stress curve of rubber-sand mixtures is the same as that of pure sand at low rubber content, but its shear strength is lower than that of pure sand; the shear stress of rubber-sand mixtures increases with the increase of vertical stress, and the shear strength of continuous gradation SR2 is the highest among the four gradations of rubber-sand mixtures; the admixture of rubber particles can effectively inhibit the dilatancy of sandy soil, among which the gap grade SR1 has the best effect on inhibiting soil dilatancy, and the dilatancyis reduced by 37% compared with that of pure sand. The internal friction angle of rubber-sand mixtures decreases with the increase of rubber content, and the internal friction angle of continuous gradation SR2 is the largest under the same rubber content; rubber particles mainly participate in the formation of weak force chain in the rubber-sand mixtures force chain network, and the shear zone width of rubber-sand mixtures is smaller than that of pure sand.

Shear Behaviour of Sand-Rubber Mixtures: Interpretation from Energy Transformation and Force Chain Evolution

Micromechanical Investigation of the Shear Behaviors of Sand‒rubber Mixtures Using a Multibody Meshfree Method

Discrete Element Modeling of Sand Behavior in a Biaxial Shear Test

The micro-mechanical behaviour of sand–rubber mixtures under shear: A numerical study based on X-ray micro-tomography

Discrete-Element Simulation of Dense Sand under Uni- and Bidirectional Cyclic Simple Shear Considering Initial Static Shear Effect

Experimental Characterization and Finite Element Modeling the Deformation Behavior of Rubbers with Geometry Defects

Evaluation of dynamic shear modulus and damping ratio of rubber-sand mixture based on cyclic simple shear tests

Stress level dependent behavior of sand-rubber mixtures

Effect of rubber particles on mechanical properties of calcareous sand under large displacement shear

Strength and deformation behaviour of sand-rubber mixture

Shear modulus of sand-rubber mixtures: element testing and constitutive modeling

EFFECT OF PARTICLE SIZE RATIO AND MIX RATIO ON MECHANICAL BEHAVIOR OF RUBBER-SAND MIXTURES

Compression characteristics and particle scale stress distribution of sand-rubber mixtures with particle size disparity effect

Effect of the particle size ratio on macro- and mesoscopic shear characteristics of the geogrid-reinforced rubber and sand mixture interface

Effect of Rubber-Sand Mixtures Gradation on Shear Characteristics of Mixed Soil

Effect of particle size and shape on shear strength of sand–rubber granule mixtures

Effect of Rubber-Sand Particle Size Ratio on Shear Properties of Rubber-Sand Mixtures under Normal Cyclic Loading

A micromechanical investigation of sand–rubber mixtures using the discrete element method

Effect of layering and pre-loading on the dynamic properties of sand-rubber specimens in resonant column tests

Influence of intermediate principal stress and rolling resistance on the shearing response of sand: a micromechanical investigation

Dynamic shear modulus and damping ratio of rubber-sand mixtures with a wide range of rubber content