Abstract:This study investigated the capillary rise potential and dynamic behavior of rubber particles-silty sand mixtures. A series of capillary rise tests and undrained cyclic triaxial tests were designed and performed on pure silty sand and rubber soil mixtures. The impact of rubber particles content (RC) and mean grain size ratio (D50,r/D50,s\documentclass[12pt]{minimal}\usepackage{amsmath}\usepackage{wasysym}\usepackage{amsfonts}\usepackage{amssymb}\usepackage{amsbsy}\usepackage{mathrsfs}\usepackage{upgreek}\setlength{\oddsidemargin}{-69pt}\begin{document}$${D}_{50,r}/{D}_{50,s}$$\end{document}) of the mixtures was investigated. The results showed that the increase of RC and D50,r/D50,s\documentclass[12pt]{minimal}\usepackage{amsmath}\usepackage{wasysym}\usepackage{amsfonts}\usepackage{amssymb}\usepackage{amsbsy}\usepackage{mathrsfs}\usepackage{upgreek}\setlength{\oddsidemargin}{-69pt}\begin{document}$${D}_{50,r}/{D}_{50,s}$$\end{document} decreased the capillary rise behavior. Compared with pure silty sand, the total capillary water mass increment of mixtures with 30% rubber particles with 41.3 and 7.9 D50,r/D50,s\documentclass[12pt]{minimal}\usepackage{amsmath}\usepackage{wasysym}\usepackage{amsfonts}\usepackage{amssymb}\usepackage{amsbsy}\usepackage{mathrsfs}\usepackage{upgreek}\setlength{\oddsidemargin}{-69pt}\begin{document}$${D}_{50,r}/{D}_{50,s}$$\end{document} decreased by 52.7% and 35.1%, respectively. An increase in D50,r/D50,s\documentclass[12pt]{minimal}\usepackage{amsmath}\usepackage{wasysym}\usepackage{amsfonts}\usepackage{amssymb}\usepackage{amsbsy}\usepackage{mathrsfs}\usepackage{upgreek}\setlength{\oddsidemargin}{-69pt}\begin{document}$${D}_{50,r}/{D}_{50,s}$$\end{document} resulted in a harder performance for the mixtures, whereas an increase in RC resulted in softer performance for the mixtures. Compared with pure silty sand, the maximum Young’s modulus of mixtures with 30% rubber particles (at 200 kPa confining pressure) for 41.3 and 7.9 D50,r/D50,s\documentclass[12pt]{minimal}\usepackage{amsmath}\usepackage{wasysym}\usepackage{amsfonts}\usepackage{amssymb}\usepackage{amsbsy}\usepackage{mathrsfs}\usepackage{upgreek}\setlength{\oddsidemargin}{-69pt}\begin{document}$${D}_{50,r}/{D}_{50,s}$$\end{document} decreased by 52.7% and 35.1%, respectively. An increase in the normalized Young’s modulus was associated with a decrease in RC\documentclass[12pt]{minimal}\usepackage{amsmath}\usepackage{wasysym}\usepackage{amsfonts}\usepackage{amssymb}\usepackage{amsbsy}\usepackage{mathrsfs}\usepackage{upgreek}\setlength{\oddsidemargin}{-69pt}\begin{document}$$\mathrm{RC}$$\end{document} and increase in D50,r/D50,s\documentclass[12pt]{minimal}\usepackage{amsmath}\usepackage{wasysym}\usepackage{amsfonts}\usepackage{amssymb}\usepackage{amsbsy}\usepackage{mathrsfs}\usepackage{upgreek}\setlength{\oddsidemargin}{-69pt}\begin{document}$${D}_{50,r}/{D}_{50,s}$$\end{document}. An increase in RC\documentclass[12pt]{minimal}\usepackage{amsmath}\usepackage{wasysym}\usepackage{amsfonts}\usepackage{amssymb}\usepackage{amsbsy}\usepackage{mathrsfs}\usepackage{upgreek}\setlength{\oddsidemargin}{-69pt}\begin{document}$$\mathrm{RC}$$\end{document} and decrease in D50,r/D50,s\documentclass[12pt]{minimal}\usepackage{amsmath}\usepackage{wasysym}\usepackage{amsfonts}\usepackage{amssymb}\usepackage{amsbsy}\usepackage{mathrsfs}\usepackage{upgreek}\setlength{\oddsidemargin}{-69pt}\begin{document}$${D}_{50,r}/{D}_{50,s}$$\end{document} resulted in an increase in damping ratio. A set of empirical equations was proposed to describe the normalized Young’s modulus and damping ratio. The results presented here provide new ideas for the use of rubber soil mixtures in geotechnical engineering.

Compression characteristics and particle scale stress distribution of sand-rubber mixtures with particle size disparity effect

Shear Behaviour of Sand-Rubber Mixtures: Interpretation from Energy Transformation and Force Chain Evolution

Micromechanical Investigation of the Shear Behaviors of Sand‒rubber Mixtures Using a Multibody Meshfree Method

Stress level dependent behavior of sand-rubber mixtures

Effect of Rubber-Sand Mixtures Gradation on Shear Characteristics of Mixed Soil

EFFECT OF PARTICLE SIZE RATIO AND MIX RATIO ON MECHANICAL BEHAVIOR OF RUBBER-SAND MIXTURES

Strength and deformation behaviour of sand-rubber mixture

Experimental Investigation on the Compressive Behavior of Rubber–Sand Mixtures under Repeated Loading–Unloading

Effect of Rubber-Sand Particle Size Ratio on Shear Properties of Rubber-Sand Mixtures under Normal Cyclic Loading

Experimental Characterization and Finite Element Modeling the Deformation Behavior of Rubbers with Geometry Defects

Experimental Investigation on the Dynamic Compressive Behavior of Rubberized Concrete

Experimental Investigation on the Compressive Behaviour of Rubber-Sand Mixtures Under Repeated Loading-Unloading

Dynamic Properties of Silty Sand Mixed with Rubber Particles for Medium Strain

A micromechanical investigation of sand–rubber mixtures using the discrete element method

Effect of the particle size ratio on macro- and mesoscopic shear characteristics of the geogrid-reinforced rubber and sand mixture interface

Effect of rubber particles on mechanical properties of calcareous sand under large displacement shear

Study on the inhibitory effect of rubber on particle breakage and the impact on the volumetric deformation of calcareous sand under different loading modes

Evaluation of dynamic shear modulus and damping ratio of rubber-sand mixture based on cyclic simple shear tests

Effect of particle size and shape on shear strength of sand–rubber granule mixtures

The micro-mechanical behaviour of sand–rubber mixtures under shear: A numerical study based on X-ray micro-tomography

Dynamic shear modulus and damping ratio of rubber-sand mixtures with a wide range of rubber content