Abstract:Huge and critical structures, such as fuel storage tanks and nuclear power plants, are often built on dense sandy grounds, which may cause excessive plastic deformations under multidirectional cyclic shearing conditions caused by earthquakes. The lack of investigation of sand behavior under multidirectional loading may lead to unsafe designs, and thus significantly increase the maintenance cost for infrastructures during their long operational time, which might be longer than 100 years. This study presents a numerical investigation on the liquefaction behavior of dense sand under bidirectional cyclic simple shear using the discrete element method. The bidirectional cyclic simple shear tests with varying stress trajectories on the deviatoric stress plane, including figure-8, circular, and straight lines, were conducted. Additionally, a series of unidirectional loading tests was conducted in the simulation scheme for comparison purposes. The effect of the initial static shear on the cyclic behavior and liquefaction resistance of granular materials was examined. Four loading categories, including full reversal, partial reversal, intermediate reversal, and no reversal, were implemented in the numerical simulations. Although the presence of the initial static shear may enhance the cyclic resistance of granular samples under unidirectional loading, it mitigates the liquefaction resistance and promotes the failure of specimens under bidirectional shearing conditions. The microscopic analysis was performed to reveal the relationship between the fabric evolution and external loading, which can provide profound insights into the underlying mechanism of the cyclic behavior and liquefaction susceptibility of granular material when both the bidirectional shearing and initial static shear effects are considered.

International Parallel Test on the Measurement of Shear Modulus of Sand Using Bender Elements

Technique Standardization of Bender Elements and International Parallel Test

Discrete Element Modeling of Sand Behavior in a Biaxial Shear Test

Development of a piezoceramic bender elements system for shear wave velocity

Measurement of Small Strain Shear Modulus of Clean and Natural Sands in Saturated Condition Using Bender Element Test

Preliminary Tests of Measuring Shear Wave Velocity on Soil Surface Using Bender Elements

Discrete-Element Simulation of Dense Sand under Uni- and Bidirectional Cyclic Simple Shear Considering Initial Static Shear Effect

Surface-mounted Bender Elements for Measuring Horizontal Shear Wave Velocity of Soils

PARAMETER SENSITIVITY ANALYSIS OF DIRECT SHEAR TEST BY PARTICLE FLOW CODE SIMULATION

Cyclic triaxial tests with controlled elastic shear modulus of specimen

Development of Bender Element System in Geotechnical Testing

Analysis on Anti-cracking Performance of High Viscoelastic Tar Sand

Experimental Study on the Anti-Cracking Performance for High Viscoelastic Asphalt Sand with SCB

Free Type Bender Elements For Characterizing Soil In Centrifuge Model Tests

A New Parameter to Evaluate Liquefaction Resistance of Saturated Sand under Complex Dynamic Stress Paths

Shear Modulus and Damping Ratio of Sand–Gravel Mixtures Over a Wide Strain Range

Feasibility study on flat shovel bulging technique with shear wave based on bending elements

Laboratory Study on Dynamic Properties of Silt and Silty Sand

Cyclic and post-cyclic direct shear behaviors of geogrid-sand interface with different soil densities

Numerical simulation of biaxial undrained shear test based on fluid–solid coupling DEM method

Assessing the Bearing Capacity of Backfills by Stress Wave Velocity and Cone Penetration Resistance