The in-situ luminescence measurements of GaN/Al 2 O 3 film under different energy proton irradiation

WenliJiang,Xiao Ouyang,Menglin Qiu,Minju Ying,LinChen,Pan Pang,Chunlei Zhang,Yaofeng Zhang,Bin Liao
DOI: https://doi.org/10.1088/1674-1056/ad1b3f
2024-01-06
Chinese Physics B
Abstract:In this paper, ion beam-induced luminescence (IBIL) experiments were performed to investigate the in-situ luminescence of GaN/Al 2 O 3 at varying ion energies, which allowed for the measurement of defects at different depths within the material. The energies of H + were set to 500 keV, 640 keV and 2 MeV, the Bragg peaks of which correspond to the GaN film, GaN/Al 2 O 3 heterojunction and Al 2 O 3 substrate, respectively. A photoluminescence (PL) measurement at 250 K was also performed for comparison, during which only near band edge (NBE) and yellow band luminescence in the GaN film were observed. The evolution of the luminescence of NBE and the yellow band in the GaN film is discussed, and both exhibit a decrease with the fluence of H + . Additionally, the luminescence of F centers, induced by oxygen vacancies, and Cr 3+ , resulting from 2 E→ 4 A 2 radiative transition in Al 2 O 3 were measured using 2 MeV H + . The luminescence intensity of F centers increases gradually with the fluence of H + . The luminescence evolution of Cr 3+ is consistent with yellow band center, attributed to its weak intensity, and it is situated within the emission band of the yellow band in the GaN film. The results show that IBIL measurement can effectively detect the luminescence behavior of multilayer films by adjusting the ion energy. Luminescence measurement can be excited by various techniques, but IBIL can satisfy the in-situ luminescence measurement and multilayer structural materials with tens of μm can be measured through IBIL by adjusting the energy of the inducing ions. The evolution of defects at different layers with ion fluence can be obtained.
physics, multidisciplinary
What problem does this paper attempt to address?